If USB UTMI PHY is not enable, writing to portsc register will lead to
kernel hang during boot up.
Signed-off-by: Shengzhou Liu <Shengzhou.Liu@xxxxxxxxxxxxx>
---
Apply for master branch of git://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux-2.6.git
Tested on P5020DS, the issue was reported by Benjamin Herrenschmidt.
drivers/usb/host/ehci-fsl.c | 4 ++++
drivers/usb/host/ehci-fsl.h | 1 +
2 files changed, 5 insertions(+), 0 deletions(-)
diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c
index c26a82e..0090ed2 100644
--- a/drivers/usb/host/ehci-fsl.c
+++ b/drivers/usb/host/ehci-fsl.c
@@ -216,6 +216,8 @@ static void ehci_fsl_setup_phy(struct ehci_hcd *ehci,
unsigned int port_offset)
{
u32 portsc;
+ struct usb_hcd *hcd = ehci_to_hcd(ehci);
+ void __iomem *non_ehci = hcd->regs;
portsc = ehci_readl(ehci, &ehci->regs->port_status[port_offset]);
portsc &= ~(PORT_PTS_MSK | PORT_PTS_PTW);
@@ -231,6 +233,8 @@ static void ehci_fsl_setup_phy(struct ehci_hcd *ehci,
portsc |= PORT_PTS_PTW;
/* fall through */
case FSL_USB2_PHY_UTMI:
+ /* enable UTMI PHY */
+ setbits32(non_ehci + FSL_SOC_USB_CTRL, CTRL_UTMI_PHY_EN);
portsc |= PORT_PTS_UTMI;
break;
case FSL_USB2_PHY_NONE:
diff --git a/drivers/usb/host/ehci-fsl.h b/drivers/usb/host/ehci-fsl.h
index bdf43e2..0e400c2 100644
--- a/drivers/usb/host/ehci-fsl.h
+++ b/drivers/usb/host/ehci-fsl.h
@@ -45,6 +45,7 @@
#define FSL_SOC_USB_PRICTRL 0x40c /* NOTE: big-endian */
#define FSL_SOC_USB_SICTRL 0x410 /* NOTE: big-endian */
#define FSL_SOC_USB_CTRL 0x500 /* NOTE: big-endian */
+#define CTRL_UTMI_PHY_EN (1<<9)
#define CTRL_PHY_CLK_VALID (1 << 17)
#define SNOOP_SIZE_2GB 0x1e
#endif /* _EHCI_FSL_H */
--
1.6.4
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
