On Sun, Jun 26, 2016 at 12:28:23AM -0700, Stephen Boyd wrote:
> The ULPI phy on qcom platforms needs to be initialized and
> powered on after a USB reset and before we toggle the run/stop
> bit. Otherwise, the phy locks up and doesn't work properly.
This requirement is so strange, try to see if any other initialization
sequences.
Since this driver is multi-platforms, I can't accept this change for
common, if you had to do that, would you please move your changes to
msm glue layer using CI_HDRC_CONTROLLER_RESET_EVENT and
CI_HDRC_CONTROLLER_STOPPED_EVENT? Besides, you need to add one flag
at ci_hdrc_platform_data.flags for your case to avoid normal
initialization.
Peter
> Move
> the phy initialization to a later point, and shut it down outside
> of driver remove so that the phy state is properly managed across
> role switches.
>
> Cc: Peter Chen <peter.chen@xxxxxxx>
> Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
> Signed-off-by: Stephen Boyd <stephen.boyd@xxxxxxxxxx>
> ---
> drivers/usb/chipidea/ci.h | 3 ++-
> drivers/usb/chipidea/core.c | 23 ++++++++++-------------
> drivers/usb/chipidea/host.c | 5 ++---
> drivers/usb/chipidea/udc.c | 2 ++
> 4 files changed, 16 insertions(+), 17 deletions(-)
>
> diff --git a/drivers/usb/chipidea/ci.h b/drivers/usb/chipidea/ci.h
> index cd414559040f..f87805235caa 100644
> --- a/drivers/usb/chipidea/ci.h
> +++ b/drivers/usb/chipidea/ci.h
> @@ -431,7 +431,8 @@ u8 hw_port_test_get(struct ci_hdrc *ci);
> int hw_wait_reg(struct ci_hdrc *ci, enum ci_hw_regs reg, u32 mask,
> u32 value, unsigned int timeout_ms);
>
> -void ci_platform_configure(struct ci_hdrc *ci);
> +void ci_usb_phy_exit(struct ci_hdrc *ci);
> +int ci_platform_configure(struct ci_hdrc *ci);
>
> int dbg_create_files(struct ci_hdrc *ci);
>
> diff --git a/drivers/usb/chipidea/core.c b/drivers/usb/chipidea/core.c
> index 01390e02ee53..a01611c7f815 100644
> --- a/drivers/usb/chipidea/core.c
> +++ b/drivers/usb/chipidea/core.c
> @@ -359,7 +359,7 @@ static int _ci_usb_phy_init(struct ci_hdrc *ci)
> * interfaces
> * @ci: the controller
> */
> -static void ci_usb_phy_exit(struct ci_hdrc *ci)
> +void ci_usb_phy_exit(struct ci_hdrc *ci)
> {
> if (ci->phy) {
> phy_power_off(ci->phy);
> @@ -412,9 +412,14 @@ static int ci_usb_phy_init(struct ci_hdrc *ci)
> * @ci: the controller
> *
> */
> -void ci_platform_configure(struct ci_hdrc *ci)
> +int ci_platform_configure(struct ci_hdrc *ci)
> {
> bool is_device_mode, is_host_mode;
> + int ret;
> +
> + ret = ci_usb_phy_init(ci);
> + if (ret)
> + return ret;
>
> is_device_mode = hw_read(ci, OP_USBMODE, USBMODE_CM) == USBMODE_CM_DC;
> is_host_mode = hw_read(ci, OP_USBMODE, USBMODE_CM) == USBMODE_CM_HC;
> @@ -453,6 +458,8 @@ void ci_platform_configure(struct ci_hdrc *ci)
> hw_write(ci, OP_BURSTSIZE, RX_BURST_MASK,
> ci->platdata->rx_burst_size);
> }
> +
> + return 0;
> }
>
> /**
> @@ -511,9 +518,7 @@ int hw_device_reset(struct ci_hdrc *ci)
> return -ENODEV;
> }
>
> - ci_platform_configure(ci);
> -
> - return 0;
> + return ci_platform_configure(ci);
> }
>
> static irqreturn_t ci_irq(int irq, void *data)
> @@ -917,12 +922,6 @@ static int ci_hdrc_probe(struct platform_device *pdev)
> ci->usb_phy = NULL;
> }
>
> - ret = ci_usb_phy_init(ci);
> - if (ret) {
> - dev_err(dev, "unable to init phy: %d\n", ret);
> - return ret;
> - }
> -
> ci->hw_bank.phys = res->start;
>
> ci->irq = platform_get_irq(pdev, 0);
> @@ -1025,7 +1024,6 @@ static int ci_hdrc_probe(struct platform_device *pdev)
> stop:
> ci_role_destroy(ci);
> deinit_phy:
> - ci_usb_phy_exit(ci);
>
> return ret;
> }
> @@ -1044,7 +1042,6 @@ static int ci_hdrc_remove(struct platform_device *pdev)
> ci_extcon_unregister(ci);
> ci_role_destroy(ci);
> ci_hdrc_enter_lpm(ci, true);
> - ci_usb_phy_exit(ci);
>
> return 0;
> }
> diff --git a/drivers/usb/chipidea/host.c b/drivers/usb/chipidea/host.c
> index 053bac9d983c..523c155daea8 100644
> --- a/drivers/usb/chipidea/host.c
> +++ b/drivers/usb/chipidea/host.c
> @@ -87,9 +87,7 @@ static int ehci_ci_reset(struct usb_hcd *hcd)
> if (ret)
> return ret;
>
> - ci_platform_configure(ci);
> -
> - return ret;
> + return ci_platform_configure(ci);
> }
>
> static const struct ehci_driver_overrides ehci_ci_overrides = {
> @@ -186,6 +184,7 @@ static void host_stop(struct ci_hdrc *ci)
> if (hcd) {
> usb_remove_hcd(hcd);
> usb_put_hcd(hcd);
> + ci_usb_phy_exit(ci);
> if (ci->platdata->reg_vbus && !ci_otg_is_fsm_mode(ci) &&
> (ci->platdata->flags & CI_HDRC_TURN_VBUS_EARLY_ON))
> regulator_disable(ci->platdata->reg_vbus);
> diff --git a/drivers/usb/chipidea/udc.c b/drivers/usb/chipidea/udc.c
> index 065f5d97aa67..8f44e2d1e0c0 100644
> --- a/drivers/usb/chipidea/udc.c
> +++ b/drivers/usb/chipidea/udc.c
> @@ -1534,6 +1534,7 @@ static int ci_udc_vbus_session(struct usb_gadget *_gadget, int is_active)
> if (ci->driver)
> ci->driver->disconnect(&ci->gadget);
> hw_device_state(ci, 0);
> + ci_usb_phy_exit(ci);
> if (ci->platdata->notify_event)
> ci->platdata->notify_event(ci,
> CI_HDRC_CONTROLLER_STOPPED_EVENT);
> @@ -1794,6 +1795,7 @@ static int ci_udc_stop(struct usb_gadget *gadget)
> ci->platdata->notify_event(ci,
> CI_HDRC_CONTROLLER_STOPPED_EVENT);
> spin_unlock_irqrestore(&ci->lock, flags);
> + ci_usb_phy_exit(ci);
> _gadget_stop_activity(&ci->gadget);
> spin_lock_irqsave(&ci->lock, flags);
> pm_runtime_put(&ci->gadget.dev);
> --
> 2.9.0.rc2.8.ga28705d
>
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
--
Best Regards,
Peter Chen
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
