On Fri, 31 Jan 2014, Dan Williams wrote:
> If a port is powered-off, or in the process of being powered-off, prevent
> khubd from operating on it. Otherwise, the following sequence of events
> leading to an unintended disconnect may occur:
>
> Events:
> (0) <set pm_qos_no_poweroff to '0' for port1>
> (1) hub 2-2:1.0: hub_resume
> (2) hub 2-2:1.0: port 1: status 0301 change 0000
> (3) hub 2-2:1.0: state 7 ports 4 chg 0002 evt 0000
> (4) hub 2-2:1.0: port 1, power off status 0000, change 0000, 12 Mb/s
> (5) usb 2-2.1: USB disconnect, device number 5
>
> Description:
> (1) hub is resumed before sending a ClearPortFeature request
> (2) hub_activate() notices the port is connected and sets
> hub->change_bits for the port
> (3) hub_events() starts, but at the same time the port suspends
> (4) hub_connect_change() sees the disabled port and triggers disconnect
> --- a/drivers/usb/core/hub.c
> +++ b/drivers/usb/core/hub.c
> @@ -4728,32 +4728,41 @@ static void port_event(struct usb_hub *hub, int port1)
> USB_PORT_FEAT_C_PORT_CONFIG_ERROR);
> }
>
> - if (hub_handle_remote_wakeup(hub, port1, portstatus, portchange))
> - connect_change = 1;
> -
> - /* Warm reset a USB3 protocol port if it's in
> - * SS.Inactive state.
> - */
> - if (hub_port_warm_reset_required(hub, portstatus)) {
> - int status;
> + /* take port actions that require the port to be powered on */
> + pm_runtime_get_noresume(&port_dev->dev);
> + pm_runtime_barrier(&port_dev->dev);
> + if (pm_runtime_active(&port_dev->dev)) {
> + if (hub_handle_remote_wakeup(hub, port1,
> + portstatus, portchange))
> + connect_change = 1;
When there is a remote wakeup request pending, we want to handle it
even if the port is powered off.
Alan Stern
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
