Re: [PATCH 0/5] Add QPIC SPI NAND driver

[Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>]

On 21/02/2024 11:34, Md Sadre Alam wrote:
> 
> 
> On 2/20/2024 5:06 PM, Krzysztof Kozlowski wrote:
>> On 20/02/2024 12:32, Md Sadre Alam wrote:
>>>
>>>
>>> On 2/19/2024 6:34 PM, Manivannan Sadhasivam wrote:
>>>> On Thu, Feb 15, 2024 at 07:18:51PM +0530, Md Sadre Alam wrote:
>>>>> This series of patches will add initial supports
>>>>> for QPIC SPI NAND driver.
>>>>>
>>>>> Currently this driver support following commands
>>>>>
>>>>> -- RESET
>>>>> -- READ ID
>>>>> -- BLOCK ERASE
>>>>> -- PAGE READ
>>>>> -- PAGE WRITE
>>>>> -- GET FEATURE
>>>>> -- SET FEATURE
>>>>> -- BAD BLOCK CHECK
>>>>>
>>>>> This driver has been tested with dd command with read/write page
>>>>> with multiple file size 1MiB, 10MiB,40MiB etc.
>>>>> Also tested with "mtd" command like mtd erase, mtd write, mtd verify etc.
>>>>>
>>>>
>>>> This is not the first version isn't it? Where is the changelog describing what
>>>> has changed since then?
>>>
>>>     The earlier patch was the RFC for design review only.
>>
>> RFC is state of patch, not version. This is v2 then.
>>
>> These RFC postings are really becoming mess. Some people make multiple
>> RFCs and then post v1 hiding entire previous history... And why even
>> bother with calling it RFC?
> 
>   Sorry, I was not aware of this. Shall I post the next one as V3
>   and add references to the RFC patch and this patch in the cover
>   letter of V3?

Yes, like with every posting.

Best regards,
Krzysztof