Re: [PATCH 0/5] Add QPIC SPI NAND driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 2/20/2024 5:06 PM, Krzysztof Kozlowski wrote:
On 20/02/2024 12:32, Md Sadre Alam wrote:


On 2/19/2024 6:34 PM, Manivannan Sadhasivam wrote:
On Thu, Feb 15, 2024 at 07:18:51PM +0530, Md Sadre Alam wrote:
This series of patches will add initial supports
for QPIC SPI NAND driver.

Currently this driver support following commands

-- RESET
-- READ ID
-- BLOCK ERASE
-- PAGE READ
-- PAGE WRITE
-- GET FEATURE
-- SET FEATURE
-- BAD BLOCK CHECK

This driver has been tested with dd command with read/write page
with multiple file size 1MiB, 10MiB,40MiB etc.
Also tested with "mtd" command like mtd erase, mtd write, mtd verify etc.


This is not the first version isn't it? Where is the changelog describing what
has changed since then?

    The earlier patch was the RFC for design review only.

RFC is state of patch, not version. This is v2 then.

These RFC postings are really becoming mess. Some people make multiple
RFCs and then post v1 hiding entire previous history... And why even
bother with calling it RFC?

 Sorry, I was not aware of this. Shall I post the next one as V3
 and add references to the RFC patch and this patch in the cover
 letter of V3?

Best regards,
Krzysztof





[Index of Archives]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux