Fill in the controller speed limits, so the SPI core can use them for validating SPI transfers, and adjusting them where needed. Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> --- v2: - No changes. drivers/spi/spi-rspi.c | 12 ++++++++++++ 1 file changed, 12 insertions(+) diff --git a/drivers/spi/spi-rspi.c b/drivers/spi/spi-rspi.c index 2b5334e22ae421b5..e39fd38f5180efb3 100644 --- a/drivers/spi/spi-rspi.c +++ b/drivers/spi/spi-rspi.c @@ -243,6 +243,8 @@ struct spi_ops { int (*transfer_one)(struct spi_controller *ctlr, struct spi_device *spi, struct spi_transfer *xfer); u16 extra_mode_bits; + u16 min_div; + u16 max_div; u16 flags; u16 fifo_size; u8 num_hw_ss; @@ -1181,6 +1183,8 @@ static int rspi_remove(struct platform_device *pdev) static const struct spi_ops rspi_ops = { .set_config_register = rspi_set_config_register, .transfer_one = rspi_transfer_one, + .min_div = 2, + .max_div = 4096, .flags = SPI_CONTROLLER_MUST_TX, .fifo_size = 8, .num_hw_ss = 2, @@ -1189,6 +1193,8 @@ static const struct spi_ops rspi_ops = { static const struct spi_ops rspi_rz_ops = { .set_config_register = rspi_rz_set_config_register, .transfer_one = rspi_rz_transfer_one, + .min_div = 2, + .max_div = 4096, .flags = SPI_CONTROLLER_MUST_RX | SPI_CONTROLLER_MUST_TX, .fifo_size = 8, /* 8 for TX, 32 for RX */ .num_hw_ss = 1, @@ -1199,6 +1205,8 @@ static const struct spi_ops qspi_ops = { .transfer_one = qspi_transfer_one, .extra_mode_bits = SPI_TX_DUAL | SPI_TX_QUAD | SPI_RX_DUAL | SPI_RX_QUAD, + .min_div = 1, + .max_div = 4080, .flags = SPI_CONTROLLER_MUST_RX | SPI_CONTROLLER_MUST_TX, .fifo_size = 32, .num_hw_ss = 1, @@ -1260,6 +1268,7 @@ static int rspi_probe(struct platform_device *pdev) int ret; const struct rspi_plat_data *rspi_pd; const struct spi_ops *ops; + unsigned long clksrc; ctlr = spi_alloc_master(&pdev->dev, sizeof(struct rspi_data)); if (ctlr == NULL) @@ -1312,6 +1321,9 @@ static int rspi_probe(struct platform_device *pdev) ctlr->unprepare_message = rspi_unprepare_message; ctlr->mode_bits = SPI_CPHA | SPI_CPOL | SPI_CS_HIGH | SPI_LSB_FIRST | SPI_LOOP | ops->extra_mode_bits; + clksrc = clk_get_rate(rspi->clk); + ctlr->min_speed_hz = DIV_ROUND_UP(clksrc, ops->max_div); + ctlr->max_speed_hz = DIV_ROUND_UP(clksrc, ops->min_div); ctlr->flags = ops->flags; ctlr->dev.of_node = pdev->dev.of_node; ctlr->use_gpio_descriptors = true; -- 2.17.1