RE: [RFC PATCH 1/2] spi: Add support for Zynq QSPI controller

[Punnaiah Choudary Kalluri <punnaiah.choudary.kalluri@xxxxxxxxxx>]

HI Greet,

>-----Original Message-----
>From: Harini Katakam [mailto:harinikatakamlinux@xxxxxxxxx]
>Sent: Thursday, July 10, 2014 3:01 PM
>To: Geert Uytterhoeven
>Cc: Mark Brown; Grant Likely; Rob Herring; Pawel Moll; Mark Rutland; Ian
>Campbell; Kumar Gala; linux-spi; linux-kernel@xxxxxxxxxxxxxxx;
>devicetree@xxxxxxxxxxxxxxx; linux-doc@xxxxxxxxxxxxxxx; David Woodhouse;
>Brian Norris; Marek Vašut; Artem Bityutskiy; Geert Uytterhoeven; Sascha
>Hauer; Jingoo Han; Sourav Poddar; Michal Simek; Punnaiah Choudary Kalluri
>Subject: Re: [RFC PATCH 1/2] spi: Add support for Zynq QSPI controller
>
>Hi Geert,
>
>On Thu, Jul 10, 2014 at 2:48 PM, Geert Uytterhoeven
><geert@xxxxxxxxxxxxxx> wrote:
>> Hi Harini,
>>
>> On Thu, Jul 10, 2014 at 10:50 AM, Harini Katakam <harinik@xxxxxxxxxx>
>wrote:
>>> +       master->flags = SPI_MASTER_QUAD_MODE;
>>
>> SPI_MASTER_QUAD_MODE is not one of the SPI_MASTER_* defines
>> in include/linux/spi/spi.h?
>>
>
>I'm sorry about that. That flag is unused - will remove this statement.
>
>>> +       master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_RX_DUAL |
>SPI_RX_QUAD |
>>> +                           SPI_TX_DUAL | SPI_TX_QUAD;
>>
>> Your driver advertises Dual/Quad SPI Transfer capabilities, but it doesn't
>> check spi_transfer.[tr]x_nbits? How can it determine when to enable
>Dual/Quad?
>>
>
>Here the driver is just giving information that the controller support it.
>The MTD layer enables dual/quad based on what the flash supports; quad
>being the first priority
>I understand that the spi core reads rx, tx-bus-width property and
>master support flags and
>performs the necessary checks.

Just to add, the zynq qspi controller will automatically select the IO lines based
On the flash command. 

Regards,
Punnaiah

>
>Regards,
>Harini
��.n��������+%������w��{.n�����{����)��jg��������ݢj����G�������j:+v���w�m������w�������h�����٥