Re: [RFC PATCH 1/2] spi: Add support for Zynq QSPI controller

[Geert Uytterhoeven <geert@xxxxxxxxxxxxxx>]

Hi Harini,

On Thu, Jul 10, 2014 at 11:31 AM, Harini Katakam
<harinikatakamlinux@xxxxxxxxx> wrote:
>>> +       master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_RX_DUAL | SPI_RX_QUAD |
>>> +                           SPI_TX_DUAL | SPI_TX_QUAD;
>>
>> Your driver advertises Dual/Quad SPI Transfer capabilities, but it doesn't
>> check spi_transfer.[tr]x_nbits? How can it determine when to enable Dual/Quad?
>
> Here the driver is just giving information that the controller support it.
> The MTD layer enables dual/quad based on what the flash supports; quad
> being the first priority
> I understand that the spi core reads rx, tx-bus-width property and
> master support flags and
> performs the necessary checks.

That's correct: as long as the rx, tx-bus-width  properties do not indicate a
Dual or Quad wiring, it won't be used.

However, based on schematics, someone may set the rx, tx-bus-width properties
to 4, which is correct, as DT describes the hardware. But this will fail to
work.
So I think it's safer not to announce Dual/Quad support in the driver until
the actual driver support is there.

Gr{oetje,eeting}s,

                        Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
                                -- Linus Torvalds
--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html