Hi Garrett: You can easily take the speaker out of your old box and put it in the new. The speakers are just plugged in with a two or three wire plastic jack that usually plugs in to the mother board at the front left corner if you have the slots pointing away from you at the back. I'll leave the orientation for your box to your mental manipulation. The speaker is almost always clipped to the case in a set of three little tangs which it is slid into. Some times they're glued but not most of the time. You may have clips already provided in your new case but if not you can just stick the speaker on to the bottom or side with the magnet on the speaker. They are pretty strong little magnets typically. You may need to have a sighty find the pins on your new mother board for the speaker and there may be more or less than the same number of pins than your speaker has wires but most of the time the plastic plug has an extra hole or two anyway. If there are two wires it doesn't matter which way it is plugged in. -- Kirk Reiser The Computer Braille Facility e-mail: kirk at braille.uwo.ca University of Western Ontario phone: (519) 661-3061