Oops. Hit the send button too soon. What to do with the info at Linmodems ... You're looking for drivers that support "Lucent Microelectronics 56k." Any drivers you find for that you get, install per directions, and try. Are you up to speed on downloading tar.gz and tar.bz, then unpacking them and compiling? On Fri, 12 Jul 2002, Octavian Rasnita wrote: > Hi all, > > I've typed the command > lspci -v > to list my PCI devices and here is what I found about my modem (a WinModem): > > 00:0a.0 Communication controller: Lucent Microelectronics 56k WinModem (rev > 01) > Subsystem: GVC Corporation LT WinModem 56k Data+Fax+Voice+VoiceView+Dsvd > Flags: bus master, medium devsel, latency 0, IRQ 9 > Memory at e4000000 (32-bit, non-prefetchable) [size=256] > I/O ports at f500 [size=8] > I/O ports at f600 [size=256] > Capabilities: [f8] Power Management version 2 > > I went to linmodems.org to find a driver for this modem, but I don't know > what to take from there because I haven't seen such a thing. > > Are there any other Linux commands that will tell me more about my modem, to > be able to find a driver for it? > > Thanks a lot. > > Teddy Center: http://teddy.fcc.ro/ > Mail: orasnita at home.ro > > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup > -- Janina Sajka, Director Technology Research and Development Governmental Relations Group American Foundation for the Blind (AFB) Email: janina at afb.net Phone: (202) 408-8175 Chair, Accessibility SIG Open Electronic Book Forum (OEBF) http://www.openebook.org
