Hi all! It's been ages! As it happens, I just solved that problem last night, at least, I hope I did. grab ftp://speakup.octothorp.org/pub/redhat-7.0/RPMS/kernel-2.2.16-22.i686.rpm. The RPMS part is uppercase. Then, do: rpm -iv --force <path>kernel-2.2.16-22.i686.rpm. Then, edit /etc/lilo.conf. Right above or below the line that says "default=linux" put: append="speakup_synth=acntsa" or you could try txprt instead of acntsa. Save the file and run lilo by typing lilo at a command prompt. Reboot, and magic should happen. Any questions, call or write. Bill in Denver On Sun, 4 Feb 2001, Al Puzzuoli wrote: > Hello, > I am attempting to get up and running with RedHat 7 and speakup on a > Toshiba Tecra 8100. I am using an Artic Transport synthesizer and the > acntsap.bin boot disk. > The install procedure talks and completes quite nicely; however, once my > system reboots into linux, I don't get any speech. Is my Linux > installation making use of the Kernel from the boot disk? If not, what do > I need to do at this point? > > Any info would be much appreciated. > > Thanks and best regards, > > Al > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup >
