Thanks Nico,
On 24/03/16 16:51, Nicolas Dechesne wrote:
On Wed, Mar 23, 2016 at 8:48 PM, Srinivas Kandagatla
<srinivas.kandagatla@xxxxxxxxxx> wrote:
+ led@1 {
+ label = "dragonboard-600c:green:user1";
+ gpios = <&tlmm_pinmux 3 GPIO_ACTIVE_HIGH>;
+ linux,default-trigger = "heartbeat";
+ default-state = "off";
+ };
+
+ led@2 {
+ label = "dragonboard-600c:green:user2";
+ gpios = <&tlmm_pinmux 7 GPIO_ACTIVE_HIGH>;
+ linux,default-trigger = "mmc0";
+ default-state = "off";
+ };
+
+ led@3 {
+ label = "dragonboard-600c:green:user3";
+ gpios = <&tlmm_pinmux 10 GPIO_ACTIVE_HIGH>;
+ linux,default-trigger = "mmc1";
+ default-state = "off";
+ };
+
+ led@4 {
+ label = "apq8016-sbc:green:user4";
typo ^^
Yep, Will fix this.
+ gpios = <&tlmm_pinmux 11 GPIO_ACTIVE_HIGH>;
+ linux,default-trigger = "none";
+ default-state = "off";
+ };
also, if i read the 96boards specs correctly, the LED are labeled
3-2-1-0 , if you look at the board with the LEDs on the bottom. With
this DT config, you end up with 0-1-2-3 instead.
also, they should be labeled 0 to 3, not 1 to 4.
I agree Will fix it. The structure was copied from the 8016.
Its strange that DB410c LEDS labels on the board are from 1 to 4 rather
than 0 to 3, on the other hand DB600c does not have any labels as such.
For Now I can change DB600c to start with 0 rather than 1.
--
To unsubscribe from this list: send the line "unsubscribe linux-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
