On Sat, Jan 06, 2024 at 05:56:34PM +0100, Krzysztof Kozlowski wrote: > On 06/01/2024 17:02, Christoph Winklhofer via B4 Relay wrote: > > Hello! > > > > This patch contains a driver for a 1-Wire bus over UART. The driver > > utilizes the UART interface via the Serial Device Bus to create the > > 1-Wire timing patterns. > > > > Changes in v4: > > - rework baud-rate configuration: also check max bit-time, support higher > > baud-rates by adding a delay to complete 1-Wire cycle. > > - dt-binding w1-uart: specify baud-rates for 1-Wire operations > > - Link to v3: https://lore.kernel.org/r/20240105-w1-uart-v3-0-8687093b2e76@xxxxxxxxx > > > > You can slow down a bit. You sent v2 too late to be applied. Then you > sent v3 and next day v4. > > While I like approach to release early, release often, it does not > necessarily apply to the bindings. Bindings should be complete, which > means they should describe the hardware as fully as possible. > > About the driver, you can develop it incrementally, it is a good idea, > however since ~rc6 my w1 tree is closed. It will remain closed till next > rc1 is released (merge window finished). Nothing will get applied during > that time, so if you intend to add new features, better to send v5 after > the merge window (instead v4 now, v5 tomorrow, v6 next week and then v7 > after rc1). > > Best regards, > Krzysztof > Ok sorry, understood - thank you for the clarification. Kind regards, Christoph
