Re: [PATCH 1/2] dt-bindings: serial: rs485: add rs485-mux-gpios binding

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Nov 23, 2023 at 11:07:16AM +0100, Rasmus Villemoes wrote:
> On 22/11/2023 15.53, Lukas Wunner wrote:
> > But if that patch gets accepted, we'd have *three* different modes:
> > RS-232, RS-485, RS-422.  A single GPIO seems insufficient to handle that.
> > You'd need at least two GPIOs.
> 
> I don't see Crescent introducing any new gpio that needs to be handled.
> In fact, I can't even see why from the perspective of the software that
> rs422 isn't just rs232; there's no transmit enable pin that needs to be
> handled. But maybe the uart driver does something different in rs422
> mode; I assume he must have some update of some driver, since otherwise
> the new rs422 bit should be rejected by the core. So I can't really see
> the whole picture of that rs422 story.

The question is, could we conceivably have the need to support
switching between the three modes RS-232, RS-485, RS-422.
If yes, then the GPIO mux interface should probably allow for that.

As a case in point, the Siemens IOT 2040 has two serial ports
which can be set to either of those three modes.  The signals
are routed to the same D-sub socket, but the pins used are
different.  See page 46 and 47 of this document:

https://cache.industry.siemens.com/dl/files/658/109741658/att_899623/v1/iot2000_operating_instructions_enUS_en-US.pdf

The driver for this product is 8250_exar.c.  It's an Intel-based
product, so no devicetree, but it shows that such use cases exist.

Thanks,

Lukas




[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux PPP]     [Linux FS]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Linmodem]     [Device Mapper]     [Linux Kernel for ARM]

  Powered by Linux