Due to one LPUART IP bug which treat the CTS as higher priority than the
break signal, that cause the break signal sending through UARTCTRL_SBK
may impacted by the CTS input if the HW flow control is enabled.
So commit c4c81db5cf8b ("tty: serial: fsl_lpuart: disable the CTS when
send break signal") try to workaround this IP issue, it disables CTS
before asserting SBK to avoid any interference from CTS, and re-enable
it when break off.
Here we enable CTS before turning off the break, there is still a risk
of the break signal been impacted by CTS input. The correct sequence is
to disable CTS before asserting SBK, and re-enable CTS after break off,
which ensures the break signal won't be impacted by CTS, so fix it.
Fixes: c4c81db5cf8b ("tty: serial: fsl_lpuart: disable the CTS when send break signal")
Signed-off-by: Sherry Sun <sherry.sun@xxxxxxx>
---
drivers/tty/serial/fsl_lpuart.c | 7 +++----
1 file changed, 3 insertions(+), 4 deletions(-)
diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
index 0e56fa64b4ce..d9e46f7b80e5 100644
--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -1550,20 +1550,19 @@ static void lpuart32_break_ctl(struct uart_port *port, int break_state)
modem = lpuart32_read(port, UARTMODIR);
if (break_state != 0) {
- temp |= UARTCTRL_SBK;
/*
* LPUART CTS has higher priority than SBK, need to disable CTS before
* asserting SBK to avoid any interference if flow control is enabled.
*/
if (cflag & CRTSCTS && modem & UARTMODIR_TXCTSE)
lpuart32_write(port, modem & ~UARTMODIR_TXCTSE, UARTMODIR);
+ lpuart32_write(port, temp | UARTCTRL_SBK, UARTCTRL);
} else {
- /* Re-enable the CTS when break off. */
+ lpuart32_write(port, temp, UARTCTRL);
+ /* Re-enable the CTS after break off. */
if (cflag & CRTSCTS && !(modem & UARTMODIR_TXCTSE))
lpuart32_write(port, modem | UARTMODIR_TXCTSE, UARTMODIR);
}
-
- lpuart32_write(port, temp, UARTCTRL);
}
static void lpuart_setup_watermark(struct lpuart_port *sport)
--
2.17.1
