In uart_set_rs485_config() the serial core already ensures that only one of
both options RTS on send or RTS after send is set.
So remove this check from the drivers rs485_config() function to avoid
redundancy.
Signed-off-by: Lino Sanfilippo <LinoSanfilippo@xxxxxx>
---
drivers/tty/serial/sc16is7xx.c | 10 ----------
1 file changed, 10 deletions(-)
diff --git a/drivers/tty/serial/sc16is7xx.c b/drivers/tty/serial/sc16is7xx.c
index 64e7e6c8145f..730f697bb517 100644
--- a/drivers/tty/serial/sc16is7xx.c
+++ b/drivers/tty/serial/sc16is7xx.c
@@ -959,16 +959,6 @@ static int sc16is7xx_config_rs485(struct uart_port *port,
struct sc16is7xx_one *one = to_sc16is7xx_one(port, port);
if (rs485->flags & SER_RS485_ENABLED) {
- bool rts_during_rx, rts_during_tx;
-
- rts_during_rx = rs485->flags & SER_RS485_RTS_AFTER_SEND;
- rts_during_tx = rs485->flags & SER_RS485_RTS_ON_SEND;
-
- if (rts_during_rx == rts_during_tx)
- dev_err(port->dev,
- "unsupported RTS signalling on_send:%d after_send:%d - exactly one of RS485 RTS flags should be set\n",
- rts_during_tx, rts_during_rx);
-
/*
* RTS signal is handled by HW, it's timing can't be influenced.
* However, it's sometimes useful to delay TX even without RTS
--
2.34.1
