On Tue, Nov 02, 2021 at 06:55:56PM +0100, Jochen wrote: > Hello, > > I have a RS485 hardware shield connected to the hardware uart of a raspberry PI3, where you have to toggle the RS485 driver DIRECTION-pin from within your software during write-commands. The DIR-Pin is connected to a GPIO pin of the PI. > > As I do not want to do that in every application software, I thought it could be a good idea to enhance the serial-port driver (locally on my PI) with that functionality. Looking to the sources of amba-pl011.c I thought the "pl011_write"-function could be the right place to do so....but to be honest it seems not to work > > Could you please give me a hint where to do that best in the serial port driver? (or is there already a RS485 driver with configurable Dir-GPIO-pin). > Is there a documentation of the serial-port architecture available which could help me to solve my problem? Other drivers do this today, using gpio pins for this. One example is the drivers/tty/serial/ar933x_uart.c driver (look at the ar933x_uart_tx_chars() function) You could do much the same in the pl011_rs485_tx_start() function when SER_RS485_RX_DURING_TX and SER_RS485_RTS_ON_SEND are checked, right? As for making it "generic", I think there are other drivers that allow the gpio pins to be selected as part of their device tree, look in the drivers/tty/serial/ directory for the use of gpio values in lots of different drivers. hope this helps, greg k-h
