On 5/6/20 8:03 PM, Bartlomiej Zolnierkiewicz wrote:
> On 5/6/20 10:02 AM, Hyunki Koo wrote:
> > Support 32-bit access for the TX/RX hold registers UTXH and URXH.
> >
> > This is required for some newer SoCs.
>
> Krzysztof has asked this previously but I couldn't find the answer in
> previous mails:
>
> Do you plan to upstream support for these newer SoCs?
>
> If not (i.e. this code is only to support Android GKI) then the code you are
> adding now may be removed at any time later during cleanups (due to
> lack of the in-kernel users).
>
> Best regards,
> --
> Bartlomiej Zolnierkiewicz
> Samsung R&D Institute Poland
> Samsung Electronics
>
> > Signed-off-by: Hyunki Koo <hyunki00.koo@xxxxxxxxxxx>
> > Reviewed-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx> Tested on Odroid
> > HC1 (Exynos5422):
> > Tested-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
> > ---
> > drivers/tty/serial/samsung_tty.c | 62
> > ++++++++++++++++++++++++++++++++++++----
> > 1 file changed, 57 insertions(+), 5 deletions(-)
> >
> > diff --git a/drivers/tty/serial/samsung_tty.c
> > b/drivers/tty/serial/samsung_tty.c
> > index 326b0164609c..6ef614d8648c 100644
> > --- a/drivers/tty/serial/samsung_tty.c
> > +++ b/drivers/tty/serial/samsung_tty.c
> > @@ -154,10 +154,33 @@ struct s3c24xx_uart_port { #define
> > portaddrl(port, reg) \
> > ((unsigned long *)(unsigned long)((port)->membase + (reg)))
> >
> > -#define rd_reg(port, reg) (readb_relaxed(portaddr(port, reg)))
> > +static u32 rd_reg(struct uart_port *port, u32 reg) {
> > + switch (port->iotype) {
> > + case UPIO_MEM:
> > + return readb_relaxed(portaddr(port, reg));
> > + case UPIO_MEM32:
> > + return readl_relaxed(portaddr(port, reg));
> > + default:
> > + return 0;
> > + }
> > + return 0;
> > +}
> > +
> > #define rd_regl(port, reg) (readl_relaxed(portaddr(port, reg)))
> >
> > -#define wr_reg(port, reg, val) writeb_relaxed(val, portaddr(port,
> > reg))
> > +static void wr_reg(struct uart_port *port, u32 reg, u32 val) {
> > + switch (port->iotype) {
> > + case UPIO_MEM:
> > + writeb_relaxed(val, portaddr(port, reg));
> > + break;
> > + case UPIO_MEM32:
> > + writel_relaxed(val, portaddr(port, reg));
> > + break;
> > + }
> > +}
> > +
> > #define wr_regl(port, reg, val) writel_relaxed(val, portaddr(port,
> > reg))
> >
> > /* Byte-order aware bit setting/clearing functions. */ @@ -1974,7
> > +1997,7 @@ static int s3c24xx_serial_probe(struct platform_device
> *pdev)
> > struct device_node *np = pdev->dev.of_node;
> > struct s3c24xx_uart_port *ourport;
> > int index = probe_index;
> > - int ret;
> > + int ret, prop = 0;
> >
> > if (np) {
> > ret = of_alias_get_id(np, "serial"); @@ -2000,10
> +2023,27 @@ static
> > int s3c24xx_serial_probe(struct platform_device *pdev)
> > dev_get_platdata(&pdev->dev) :
> > ourport->drv_data->def_cfg;
> >
> > - if (np)
> > + if (np) {
> > of_property_read_u32(np,
> > "samsung,uart-fifosize", &ourport->port.fifosize);
> >
> > + if (of_property_read_u32(np, "reg-io-width", &prop) ==
> 0) {
> > + switch (prop) {
> > + case 1:
> > + ourport->port.iotype = UPIO_MEM;
> > + break;
> > + case 4:
> > + ourport->port.iotype = UPIO_MEM32;
> > + break;
> > + default:
> > + dev_warn(&pdev->dev, "unsupported
> reg-io-width (%d)\n",
> > + prop);
> > + ret = -EINVAL;
> > + break;
> > + }
> > + }
> > + }
> > +
> > if (ourport->drv_data->fifosize[index])
> > ourport->port.fifosize = ourport->drv_data-
> >fifosize[index];
> > else if (ourport->info->fifosize)
> > @@ -2587,6 +2627,18 @@
> module_platform_driver(samsung_serial_driver);
> > * Early console.
> > */
> >
> > +static void wr_reg_barrier(struct uart_port *port, u32 reg, u32 val)
> > +{
> > + switch (port->iotype) {
> > + case UPIO_MEM:
> > + writeb(val, portaddr(port, reg));
> > + break;
> > + case UPIO_MEM32:
> > + writel(val, portaddr(port, reg));
> > + break;
> > + }
> > +}
> > +
> > struct samsung_early_console_data {
> > u32 txfull_mask;
> > };
> > @@ -2612,7 +2664,7 @@ static void samsung_early_putc(struct
> uart_port *port, int c)
> > else
> > samsung_early_busyuart(port);
> >
> > - writeb(c, port->membase + S3C2410_UTXH);
> > + wr_reg_barrier(port, S3C2410_UTXH, c);
> > }
> >
> > static void samsung_early_write(struct console *con, const char *s,
> >
Hi
We don't have plan to upstream for new SOCs yet,
This code is only to support Android GKI,
But it should not be not removed
