RE: [PATCH v2] tty: samsung_tty: 32-bit access for TX/RX hold registers

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Apr 02, 2020 at 10:59:29PM +0900, Krzysztof Kozlowski
> On Thu, Apr 02, 2020 at 08:04:29PM +0900, Hyunki Koo wrote:
> > Support 32-bit access for the TX/RX hold registers UTXH and URXH.
> >
> > This is required for some newer SoCs.
> >
> > Signed-off-by: Hyunki Koo <hyunki00.koo@xxxxxxxxxxx>
> > ---
> >  drivers/tty/serial/samsung_tty.c | 78
> > +++++++++++++++++++++++++++++++++-------
> >  1 file changed, 66 insertions(+), 12 deletions(-)
> >
> > diff --git a/drivers/tty/serial/samsung_tty.c
> > b/drivers/tty/serial/samsung_tty.c
> > index 73f951d65b93..826d8c5846a6 100644
> > --- a/drivers/tty/serial/samsung_tty.c
> > +++ b/drivers/tty/serial/samsung_tty.c
> > @@ -154,12 +154,47 @@ struct s3c24xx_uart_port {  #define
> > portaddrl(port, reg) \
> >  	((unsigned long *)(unsigned long)((port)->membase + (reg)))
> >
> > -#define rd_regb(port, reg) (readb_relaxed(portaddr(port, reg)))
> > +static unsigned int rd_reg(struct uart_port *port, int reg) {
> > +	switch (port->iotype) {
> > +	case UPIO_MEM:
> > +		return readb_relaxed(portaddr(port, reg));
> > +	case UPIO_MEM32:
> > +		return readl_relaxed(portaddr(port, reg));
> > +	default:
> > +		return 0;
> > +	}
> > +	return 0;
> > +}
> > +
> >  #define rd_regl(port, reg) (readl_relaxed(portaddr(port, reg)))
> >
> > -#define wr_regb(port, reg, val) writeb_relaxed(val, portaddr(port,
> > reg))
> > +static void wr_reg(struct uart_port *port, int reg, int val) {
> > +	switch (port->iotype) {
> > +	case UPIO_MEM:
> > +		writeb_relaxed(val, portaddr(port, reg));
> > +		break;
> > +	case UPIO_MEM32:
> > +		writel_relaxed(val, portaddr(port, reg));
> > +		break;
> > +	}
> > +}
> > +
> >  #define wr_regl(port, reg, val) writel_relaxed(val, portaddr(port,
> > reg))
> >
> > +static void write_buf(struct uart_port *port, int reg, int val) {
> > +	switch (port->iotype) {
> > +	case UPIO_MEM:
> > +		writeb(val, portaddr(port, reg));
> > +		break;
> > +	case UPIO_MEM32:
> > +		writel(val, portaddr(port, reg));
> > +		break;
> > +	}
> > +}
> > +
> >  /* Byte-order aware bit setting/clearing functions. */
> >
> >  static inline void s3c24xx_set_bit(struct uart_port *port, int idx,
> > @@ -714,7 +749,7 @@ static void s3c24xx_serial_rx_drain_fifo(struct
> s3c24xx_uart_port *ourport)
> >  		fifocnt--;
> >
> >  		uerstat = rd_regl(port, S3C2410_UERSTAT);
> > -		ch = rd_regb(port, S3C2410_URXH);
> > +		ch = rd_reg(port, S3C2410_URXH);
> >
> >  		if (port->flags & UPF_CONS_FLOW) {
> >  			int txe = s3c24xx_serial_txempty_nofifo(port);
> > @@ -826,7 +861,7 @@ static irqreturn_t s3c24xx_serial_tx_chars(int
> irq, void *id)
> >  	}
> >
> >  	if (port->x_char) {
> > -		wr_regb(port, S3C2410_UTXH, port->x_char);
> > +		wr_reg(port, S3C2410_UTXH, port->x_char);
> >  		port->icount.tx++;
> >  		port->x_char = 0;
> >  		goto out;
> > @@ -852,7 +887,7 @@ static irqreturn_t s3c24xx_serial_tx_chars(int
> irq, void *id)
> >  		if (rd_regl(port, S3C2410_UFSTAT) & ourport->info-
> >tx_fifofull)
> >  			break;
> >
> > -		wr_regb(port, S3C2410_UTXH, xmit->buf[xmit->tail]);
> > +		wr_reg(port, S3C2410_UTXH, xmit->buf[xmit->tail]);
> >  		xmit->tail = (xmit->tail + 1) & (UART_XMIT_SIZE - 1);
> >  		port->icount.tx++;
> >  		count--;
> > @@ -916,7 +951,7 @@ static unsigned int
> s3c24xx_serial_tx_empty(struct
> > uart_port *port)
> >  /* no modem control lines */
> >  static unsigned int s3c24xx_serial_get_mctrl(struct uart_port *port)
> > {
> > -	unsigned int umstat = rd_regb(port, S3C2410_UMSTAT);
> > +	unsigned int umstat = rd_reg(port, S3C2410_UMSTAT);
> >
> >  	if (umstat & S3C2410_UMSTAT_CTS)
> >  		return TIOCM_CAR | TIOCM_DSR | TIOCM_CTS; @@ -
> 1974,7 +2009,7 @@
> > static int s3c24xx_serial_probe(struct platform_device *pdev)
> >  	struct device_node *np = pdev->dev.of_node;
> >  	struct s3c24xx_uart_port *ourport;
> >  	int index = probe_index;
> > -	int ret;
> > +	int ret, prop = 0;
> >
> >  	if (np) {
> >  		ret = of_alias_get_id(np, "serial"); @@ -2000,10
> +2035,29 @@ static
> > int s3c24xx_serial_probe(struct platform_device *pdev)
> >  			dev_get_platdata(&pdev->dev) :
> >  			ourport->drv_data->def_cfg;
> >
> > -	if (np)
> > +	if (np) {
> >  		of_property_read_u32(np,
> >  			"samsung,uart-fifosize", &ourport->port.fifosize);
> >
> > +		if (of_property_read_u32(np, "reg-io-width", &prop) ==
> 0) {
> > +			switch (prop) {
> > +			case 1:
> > +				ourport->port.iotype = UPIO_MEM;
> > +				break;
> > +			case 4:
> > +				ourport->port.iotype = UPIO_MEM32;
> > +				break;
> > +			default:
> > +				dev_warn(&pdev->dev, "unsupported
> reg-io-width (%d)\n",
> > +						prop);
> > +				ret = -EINVAL;
> > +				break;
> > +			}
> > +		} else {
> > +			ourport->port.iotype = UPIO_MEM;
> > +		}
> > +	}
> 
> I think this still breaks all non-DT platforms (e.g. s3c).
> 
> Best regards,
> Krzysztof

Thank you for your comment.
I  hope ourport->port.iotype  is initialized by below table for non-DT platforms

1662 static struct s3c24xx_uart_port                                         
1663 s3c24xx_serial_ports[CONFIG_SERIAL_SAMSUNG_UARTS] = {                   
1664         [0] = {                                                         
1665                 .port = {                                               
1666                         .lock           = __PORT_LOCK_UNLOCKED(0),      
1667                         .iotype         = UPIO_MEM,                     
1668                         .uartclk        = 0,                            
1669                         .fifosize       = 16,                           
1670                         .ops            = &s3c24xx_serial_ops,          
1671                         .flags          = UPF_BOOT_AUTOCONF,            
1672                         .line           = 0,                            
1673                 }                                                       
1674         },                                                              
1675         [1] = {                                                         
1676                 .port = {                                               
1677                         .lock           = __PORT_LOCK_UNLOCKED(1),      
1678                         .iotype         = UPIO_MEM,                     
1679                         .uartclk        = 0,                            
1680                         .fifosize       = 16,                           
1681                         .ops            = &s3c24xx_serial_ops,          
1682                         .flags          = UPF_BOOT_AUTOCONF,            
1683                         .line           = 1,                            
1684                 }                                                       
1685         },





[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux PPP]     [Linux FS]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Linmodem]     [Device Mapper]     [Linux Kernel for ARM]

  Powered by Linux