On 2019-01-23 10:35, Georgi Djakov wrote:
Hi Alok,
Thanks for the patches!
On 1/22/19 08:33, Alok Chauhan wrote:
Add documentation for the interconnect and interconnect-names bindings
s/interconnect /interconnects /
for the GENI QUP as detailed by
bindings/interconnect/interconnect.txt.
Signed-off-by: Alok Chauhan <alokc@xxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt | 10
++++++++++
1 file changed, 10 insertions(+)
diff --git
a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
index dab7ca9..44d7e02 100644
--- a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
+++ b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
@@ -17,6 +17,12 @@ Required properties if child node exists:
- #address-cells: Must be <1> for Serial Engine Address
- #size-cells: Must be <1> for Serial Engine Address Size
- ranges: Must be present
+- interconnects: phandle to a interconnect provider. Please refer
s/a interconnect/an interconnect/
sure, will do.
+ ../interconnect/interconnect.txt for details.
+ Must be 2 paths corresponding to 2 AXI ports.
+- interconnect-names: Port names to differentiate between the
+ 2 interconnect paths defined with interconnect
+ specifier.
Properties for children:
@@ -67,6 +73,10 @@ Example:
#size-cells = <1>;
ranges;
+ interconnects = <&qnoc 11 &qnoc 512>,
+ <&qnoc 0 &qnoc 543>;
Please take a snippet from your patch 6/6 and put it here instead of
the
hard-coded integers above.
sure
+ interconnect-names = "qup-memory", "qup-config";
+
i2c0: i2c@a94000 {
compatible = "qcom,geni-i2c";
reg = <0xa94000 0x4000>;
When you post a new version, please change the subject of the patch
series to PATCH v2, PATCH v3 etc, in order to be able to distinguish
between different versions.
sure, will do this.
Thanks,
Georgi
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora
Forum,a Linux Foundation Collaborative Project
