On Fri, May 26, 2017 at 7:02 PM, Jan Kiszka <jan.kiszka@xxxxxxxxxxx> wrote:
> This implements the setup of RS232 and the switch-over to RS485 or RS422
> for the Siemens IOT2040. That uses an EXAR XR17V352 with external logic
> to switch between the different modes. The external logic is controlled
> via MPIO pins of the EXAR controller.
>
> Only pin 10 can be exported as GPIO on the IOT2040. It is connected to
> an LED.
>
> As the XR17V352 used on the IOT2040 is not equipped with an external
> EEPROM, it cannot present itself as IOT2040-variant via subvendor/
> subdevice IDs. Thus, we have to check via DMI for the target platform.
> static void *
> -xr17v35x_register_gpio(struct pci_dev *pcidev, unsigned int first_pin,
> - unsigned int npins)
> +__xr17v35x_register_gpio(struct pci_dev *pcidev, unsigned int first_pin,
> + unsigned int npins)
> +static int xr17v35x_register_gpio(struct pci_dev *pcidev,
> + struct uart_8250_port *port)
> +{
> + if (pcidev->vendor == PCI_VENDOR_ID_EXAR)
> + port->port.private_data =
> + __xr17v35x_register_gpio(pcidev, 0, 16);
> +
> + return 0;
> +}
> - if (pcidev->vendor == PCI_VENDOR_ID_EXAR)
> - port->port.private_data =
> - xr17v35x_register_gpio(pcidev, 0, 16);
> + ret = platform->register_gpio(pcidev, port);
> }
Can't you move at least some of this to the patch where you move the check?
--
With Best Regards,
Andy Shevchenko
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
