Hi! This series implements support for using RX FIFO thresholds higher than one in PIO mode on SCIF, HSCIF, SCIFA and SCIFB serial ports. This revision addresses the issues found by Geert and Sergei in their reviews, see below for details. Setting the RX trigger on SH77xx-style ports is still not handled correctly, mostly because we don't have any hardware to test against. I have changed the trigger default for these ports to 1 to avoid regressions. CU Uli Changes since v1: - clarify HS trigger register enum - simplify DR bit handling - if() cascade -> switch() - disable RX trigger for SH77xx-style ports - clean up on failure to create sysfs attribute - r8a7796 DT: add control pins, rtscts flag Ulrich Hecht (7): serial: sh-sci: add FIFO trigger bits serial: sh-sci: consider DR (data ready) bit adequately serial: sh-sci: implement FIFO threshold register setting serial: sh-sci: increase RX FIFO trigger defaults for (H)SCIF serial: sh-sci: SCIFA/B RX FIFO software timeout serial: sh-sci: make RX FIFO parameters tunable via sysfs arm64: dts: r8a7796: salvator-x: add SCIF1 (DEBUG1) arch/arm64/boot/dts/renesas/r8a7796-salvator-x.dts | 14 ++ drivers/tty/serial/sh-sci.c | 259 ++++++++++++++++++--- drivers/tty/serial/sh-sci.h | 8 +- 3 files changed, 248 insertions(+), 33 deletions(-) -- 2.7.4 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html