From: Wan Ahmad Zainie <wan.ahmad.zainie.wan.mohamad@xxxxxxxxx>
Bay Trail UART port does not support DCD and DSR lines. The driver
shall report that these signals are permanently active. This patch
is for HSUART enumerated via PCI.
For ACPI, see commit serial: 8250_dw: Fix get_mctrl behaviour. The
commit also describes the possible issue if these signals are enabled
on a port without these pins.
Signed-off-by: Wan Ahmad Zainie <wan.ahmad.zainie.wan.mohamad@xxxxxxxxx>
---
drivers/tty/serial/8250/8250_pci.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/drivers/tty/serial/8250/8250_pci.c b/drivers/tty/serial/8250/8250_pci.c
index 98862aa..149f535 100644
--- a/drivers/tty/serial/8250/8250_pci.c
+++ b/drivers/tty/serial/8250/8250_pci.c
@@ -1413,6 +1413,17 @@ static bool byt_dma_filter(struct dma_chan *chan, void *param)
return true;
}
+static unsigned int
+byt_get_mctrl(struct uart_port *port)
+{
+ unsigned int ret = serial8250_do_get_mctrl(port);
+
+ /* Force DCD and DSR signals to permanently be reported as active. */
+ ret |= TIOCM_CAR | TIOCM_DSR;
+
+ return ret;
+}
+
static int
byt_serial_setup(struct serial_private *priv,
const struct pciserial_board *board,
@@ -1477,6 +1488,7 @@ byt_serial_setup(struct serial_private *priv,
port->port.type = PORT_16550A;
port->port.flags = (port->port.flags | UPF_FIXED_PORT | UPF_FIXED_TYPE);
port->port.set_termios = byt_set_termios;
+ port->port.get_mctrl = byt_get_mctrl;
port->port.fifosize = 64;
port->tx_loadsz = 64;
port->dma = dma;
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
