Commit 88838d3112702 ("serial: omap_8250: Fix RTS handling") fixed
RTS pin control when in autoRTS mode.
New support added in "serial: core: Rework hw-assisted flow control support"
enables a much simpler approach; rather than masking out autoRTS
whenever writing the EFR register, use the UPSTAT_* mode to determine if
autoRTS should be enabled when raising RTS (in omap8250_set_mctrl()).
Signed-off-by: Peter Hurley <peter@xxxxxxxxxxxxxxxxxx>
---
drivers/tty/serial/8250/8250_omap.c | 16 +++++++---------
1 file changed, 7 insertions(+), 9 deletions(-)
diff --git a/drivers/tty/serial/8250/8250_omap.c b/drivers/tty/serial/8250/8250_omap.c
index 4473881..59d6e90 100644
--- a/drivers/tty/serial/8250/8250_omap.c
+++ b/drivers/tty/serial/8250/8250_omap.c
@@ -120,10 +120,11 @@ static void omap8250_set_mctrl(struct uart_port *port, unsigned int mctrl)
*/
lcr = serial_in(up, UART_LCR);
serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B);
- if (mctrl & TIOCM_RTS)
- serial_out(up, UART_EFR, priv->efr);
+ if ((mctrl & TIOCM_RTS) && (port->status & UPSTAT_AUTORTS))
+ priv->efr |= UART_EFR_RTS;
else
- serial_out(up, UART_EFR, priv->efr & ~UART_EFR_RTS);
+ priv->efr &= ~UART_EFR_RTS;
+ serial_out(up, UART_EFR, priv->efr);
serial_out(up, UART_LCR, lcr);
}
@@ -272,10 +273,7 @@ static void omap8250_restore_regs(struct uart_8250_port *up)
serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B);
serial_dl_write(up, priv->quot);
- if (up->port.mctrl & TIOCM_RTS)
- serial_out(up, UART_EFR, priv->efr);
- else
- serial_out(up, UART_EFR, priv->efr & ~UART_EFR_RTS);
+ serial_out(up, UART_EFR, priv->efr);
/* Configure flow control */
serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B);
@@ -424,9 +422,9 @@ static void omap_8250_set_termios(struct uart_port *port,
up->port.status &= ~(UPSTAT_AUTOCTS | UPSTAT_AUTORTS | UPSTAT_AUTOXOFF);
if (termios->c_cflag & CRTSCTS && up->port.flags & UPF_HARD_FLOW) {
- /* Enable AUTORTS and AUTOCTS */
+ /* Enable AUTOCTS (autoRTS is enabled when RTS is raised) */
up->port.status |= UPSTAT_AUTOCTS | UPSTAT_AUTORTS;
- priv->efr |= UART_EFR_CTS | UART_EFR_RTS;
+ priv->efr |= UART_EFR_CTS;
} else if (up->port.flags & UPF_SOFT_FLOW) {
/*
* IXON Flag:
--
2.2.2
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
