serial: sh-sci: Hardware flow control update [PATCH 01/05] serial: sh-sci: Break out default CTS/RTS pin setup [PATCH 02/05] serial: sh-sci: Fix default RTS handling [PATCH 03/05] serial: sh-sci: Expose default CTS pin [PATCH 04/05] serial: sh-sci: Add SCIFA/SCIFB CTS/RTS pin setup [PATCH 05/05] serial: sh-sci: Expose SCIFA/SCIFB CTS pin These patches are my first stab at improving CTS/RTS pin handling in the SCIF driver. The goal for these patches is to improve the default hardware flow control handling and also add CTS/RTS support for SCIFA/SCIFB. The SCIF hardware does not provide any interrupt driven delta monitoring of any modem control signals such as CTS. Instead the different SCIF types tend to include "automatic" hardware handling of the CTS and RTS signals. Things like CTS/RTS pin setup, RTS trigger level and FIFO size seem to vary with each SCIF variant, but the actual harware flow control logic should be the same if you trust the documentation. The hardware flow control support can be enabled by setting the SCFCR.MCE bit in the hardware which will enable the following behavior: CTS: TX FIFO contents are sent as long as CTS remains asserted. RTS: RTS is asserted as long as enough space remains in the RX FIFO. Depending on SCIF variant it may be theoretically possible to enable hardware handling of only one of the signals in the SCIF device. In other cases the pin control hardware in the SoC may be used to disable handling of a certain pin. Most embedded boards using SCIF tend to only hook up RX and TX signals while some special cases like KZM9G have the SCIFA console port connected with CTS and RTS signals available as well. Getting support for CTS/RTS on a particular board involves the following: - The SCIF variant on the SoC that has CTS/RTS support for the channel. - The target board must enable all SCIF pins in the pin control hardware. - The driver instance must be marked as CTS/RTS capable with SCIx_HAVE_RTSCTS. - User space should signal that it wants to use CTS/RTS via CRTSCTS. - In case CRTSCTS is not desired then the CTS/RTS pins need to be setup anyway. At this point UPF_HARD_FLOW is not used by the driver. Lightly tested with local SCIx_HAVE_RTSCTS enablement on the KZM9G board. Signed-off-by: Magnus Damm <damm+renesas@xxxxxxxxxxxxx> --- Built on top of renesas-devel-20141217-v3.18 drivers/tty/serial/sh-sci.c | 147 +++++++++++++++++++++++++++++++++++++------ include/linux/serial_sci.h | 4 + 2 files changed, 132 insertions(+), 19 deletions(-) -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
