On Wed, Sep 10, 2014 at 09:29:57PM +0200, Sebastian Andrzej Siewior wrote:
> +/*
> + * This two wrapper ensure, that enable_runtime_pm_tx() can be called more than
These two wrappers ensure that enable_runtime_pm_tx() ...
> + * once and disable_runtime_pm_tx() will still disable RPM because the fifo is
> + * empty and the HW can idle again.
> + */
> +static void serial8250_rpm_get_tx(struct uart_8250_port *p)
> +{
> + unsigned char rpm_active;
> +
> + if (!(p->capabilities & UART_CAP_RPM))
> + return;
> +
> + rpm_active = xchg(&p->rpm_tx_active, 1);
> + if (rpm_active)
> + return;
> + pm_runtime_get_sync(p->port.dev);
> +}
> +
> +static void serial8250_rpm_put_tx(struct uart_8250_port *p)
> +{
> + unsigned char rpm_active;
> +
> + if (!(p->capabilities & UART_CAP_RPM))
> + return;
> +
> + rpm_active = xchg(&p->rpm_tx_active, 0);
> + if (!rpm_active)
> + return;
> + pm_runtime_mark_last_busy(p->port.dev);
> + pm_runtime_put_autosuspend(p->port.dev);
> +}
> +
> @@ -1469,7 +1531,12 @@ void serial8250_tx_chars(struct uart_8250_port *up)
>
> DEBUG_INTR("THRE...");
>
> - if (uart_circ_empty(xmit))
> + /*
> + * With RPM enabled, we have to wait once the FIFO is empty before the
s,once,until,? Or do I not understand the sentence correctly?
> + * HW can go idle. So we get here once again with empty FIFO and disable
> + * the interrupt and RPM in __stop_tx()
> + */
> + if (uart_circ_empty(xmit) && !(up->capabilities & UART_CAP_RPM))
> __stop_tx(up);
> }
> EXPORT_SYMBOL_GPL(serial8250_tx_chars);
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
