On Tue, Jun 18, 2013 at 12:12:53PM -0700, David Daney wrote:
> A few differences needed by OCTEON:
>
> o These are DWC UARTS, but have USR at a different offset.
>
> o OCTEON must have 64-bit wide register accesses, so we have OCTEON
> specific register accessors.
>
> o No UCV register, so we hard code some properties.
>
> Signed-off-by: David Daney <david.daney@xxxxxxxxxx>
<snip>
> @@ -270,10 +301,8 @@ static int dw8250_probe(struct platform_device *pdev)
> uart.port.serial_out = dw8250_serial_out;
> uart.port.private_data = data;
>
> - dw8250_setup_port(&uart);
> -
> if (pdev->dev.of_node) {
> - err = dw8250_probe_of(&uart.port);
> + err = dw8250_probe_of(&uart.port, data);
> if (err)
> return err;
> } else if (ACPI_HANDLE(&pdev->dev)) {
> @@ -284,6 +313,9 @@ static int dw8250_probe(struct platform_device *pdev)
> return -ENODEV;
> }
>
> + if (!data->no_ucv)
> + dw8250_setup_port(&uart);
Moving the dw8250_setup_port() call here breaks dw8250_probe_acpi(). It
expects values from the CPR register for the DMA burst size calculation.
The DMA support can be moved to a separate function. This way it can
be called after this point, and it will then be available for both DT
and ACPI. I can make a patch tomorrow. That should solve this issue.
Thanks,
--
heikki
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
