On Tue, 28 Sep 2021 18:54:31 -0500, Don Brace wrote: > These patches are based on Martin Petersen's 5.16/scsi-queue tree > https://git.kernel.org/pub/scm/linux/kernel/git/mkp/scsi.git > 5.16/scsi-queue > > This set of changes consist of: > * Aligning device removal with our out of box driver. > * Aligning kdump timing with controller memory dump. > The OS was rebooting before the controller was finished dumping its own > memory. Now the driver will wait for the controller to indicate that its > dump has completed. > * In rare cases where the controller stops responding to the driver, the > driver can set reason codes to aid in debugging. > * Enhance device reset operations. The driver was not obtaining the current > number of outstanding commands during the check for outstanding command > completions. This was causing reset hangs. > * Add in a check for HBA devices undergoing sanitize. This was causing long > boot up delays while the OS waited for sanitize to complete. The fix is to > check for sanitize and keep the HBA disk offline. Note that the SSA spec > states that the disk must be manually re-enabled after sanitize has > completed. The link to the spec is noted in the patch. > * When the OS off-lines a disk, the SCSI command pointers are cleaned up. > The driver was attempting to return some outstanding commands that were > no longer valid. > * Add in more enhanced report physical luns (RPL) command. This is an > internal command that yields more complete WWID information. > * Correct a rare case where a poll for a register status before the > register has been updated. > * When multi-LUN tape devices are added to the OS, the OS does its own > report LUNs and the tape devices were duplicated. A simple fix was to update > slave_alloc/slave_configure to prevent this. > * Add in some new PCI devices. > * Bump the driver version. > > [...] Applied to 5.16/scsi-queue, thanks! [01/11] smartpqi: update device removal management https://git.kernel.org/mkp/scsi/c/819225b03dc7 [02/11] smartpqi: add controller handshake during kdump https://git.kernel.org/mkp/scsi/c/9ee5d6e9ac52 [03/11] smartpqi: capture controller reason codes https://git.kernel.org/mkp/scsi/c/5d1f03e6f49a [04/11] smartpqi: update LUN reset handler https://git.kernel.org/mkp/scsi/c/6ce1ddf53252 [05/11] smartpqi: add tur check for sanitize operation https://git.kernel.org/mkp/scsi/c/be76f90668d8 [06/11] smartpqi: avoid failing ios for offline devices https://git.kernel.org/mkp/scsi/c/4f3cefc3084d [07/11] smartpqi: add extended report physical luns https://git.kernel.org/mkp/scsi/c/28ca6d876c5a [08/11] smartpqi: fix boot failure during lun rebuild https://git.kernel.org/mkp/scsi/c/987d35605b7e [09/11] smartpqi: fix duplicate device nodes for tape changers https://git.kernel.org/mkp/scsi/c/d4dc6aea93cb [10/11] smartpqi: add 3252-8i pci id https://git.kernel.org/mkp/scsi/c/80982656b78e [11/11] smartpqi: update version to 2.1.12-055 https://git.kernel.org/mkp/scsi/c/605ae389ea02 -- Martin K. Petersen Oracle Linux Engineering
