Hi Bart, > On Nov 19, 2019, at 6:15 PM, Bart Van Assche <bvanassche@xxxxxxx> wrote: > > On 11/13/19 6:34 PM, Bart Van Assche wrote: >> On 2019-11-13 07:29, Himanshu Madhani wrote: >>> On Nov 11, 2019, at 8:48 PM, Bart Van Assche <bvanassche@xxxxxxx> wrote: >>>> Himanshu, can you tell us which adapters and/or firmware versions need >>>> which version of the above code? >>> >>> All adapters with FW v4.4 will behave same. If you are running into issue with P2P connection, >>> it might be something different than specific to this code change. Original code in the driver was not >>> following firmware spec. This code is now used in initiator mode as well due to introduction of >>> FC-NVMe handling in the driver. Also, can you tell me what version of firmware you have on your >>> remote port. >> Hi Himanshu, >> My test was run on a setup with a single QLE2562 adapter with both FC >> ports connected directly to each other. The kernel driver identifies >> that adapter as follows: ISP2532: PCIe (5.0GT/s x8) @ 0000:00:0a.0 hdma+ >> host#=12 fw=8.07.00 (90d5). Please let me know if you need more information. > > Ping? > > Bart. Sorry for delay. Can you send me log file with ql2xextended_error_logging=0x5200b000 to see why you are seeing issue in your setup and if possible trigger FW dump and send me that as well right after you see this issue. I’ll have to check with my firmware guys on the behavior you are seeing. Thanks, Himanshu
