Re: [PATCH] Revert "qla2xxx: Fix Nport ID display value"

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 2019-11-13 07:29, Himanshu Madhani wrote:
> On Nov 11, 2019, at 8:48 PM, Bart Van Assche <bvanassche@xxxxxxx> wrote:
>> Himanshu, can you tell us which adapters and/or firmware versions need
>> which version of the above code?
> 
> All adapters with FW v4.4 will behave same. If you are running into issue with P2P connection,
> it might be something different than specific to this code change. Original code in the driver was not
> following firmware spec. This code is now used in initiator mode as well due to introduction of
> FC-NVMe handling in the driver.  Also, can you tell me what version of firmware you have on your 
> remote port.

Hi Himanshu,

My test was run on a setup with a single QLE2562 adapter with both FC
ports connected directly to each other. The kernel driver identifies
that adapter as follows: ISP2532: PCIe (5.0GT/s x8) @ 0000:00:0a.0 hdma+
host#=12 fw=8.07.00 (90d5). Please let me know if you need more information.

Thanks,

Bart.




[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Index of Archives]     [SCSI Target Devel]     [Linux SCSI Target Infrastructure]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Linux IIO]     [Samba]     [Device Mapper]

  Powered by Linux