On 11/13/19 6:34 PM, Bart Van Assche wrote:
On 2019-11-13 07:29, Himanshu Madhani wrote:
On Nov 11, 2019, at 8:48 PM, Bart Van Assche <bvanassche@xxxxxxx> wrote:
Himanshu, can you tell us which adapters and/or firmware versions need
which version of the above code?
All adapters with FW v4.4 will behave same. If you are running into issue with P2P connection,
it might be something different than specific to this code change. Original code in the driver was not
following firmware spec. This code is now used in initiator mode as well due to introduction of
FC-NVMe handling in the driver. Also, can you tell me what version of firmware you have on your
remote port.
Hi Himanshu,
My test was run on a setup with a single QLE2562 adapter with both FC
ports connected directly to each other. The kernel driver identifies
that adapter as follows: ISP2532: PCIe (5.0GT/s x8) @ 0000:00:0a.0 hdma+
host#=12 fw=8.07.00 (90d5). Please let me know if you need more information.
Ping?
Bart.
