On Thu, 2006-09-07 at 09:04 -0500, James Bottomley wrote:
> On Thu, 2006-09-07 at 11:15 +0200, Olaf Hering wrote:
> > This does not work: ahc_linux_get_signalling: f 56f6
> >
> > echo $(( 0x56f6 & 0x00002 )) gives 2, and the ahc_inb is called.
>
> Erm, there's something else going on then: An ultra 2 card has to have
> this register. It's used to signal mode changes in
> ahc_handle_scsiint(). The piece of code in there will trigger and read
> this register for any ultra 2 + controller every time there's an error
> (just to see if the bus mode changed).
Sorry for my belated response, but this usually happens when you access
an aic chipset too soon after a chip reset. Try putting a delay before
whatever access is causing this to see if it make s difference. Common
problems include after a chip reset, touching any register will cause
the card to reset, etc.
--
Doug Ledford <dledford@xxxxxxxxxx>
GPG KeyID: CFBFF194
http://people.redhat.com/dledford
Infiniband specific RPMs available at
http://people.redhat.com/dledford/Infiniband
Attachment:
signature.asc
Description: This is a digitally signed message part
