Hi Marek, Am 25.11.2016 um 15:45 schrieb Marek Szyprowski: > On 2016-11-25 15:02, Markus Reichl wrote: >> Am 25.11.2016 um 14:39 schrieb Marek Szyprowski: >>> On 2016-11-24 15:13, Markus Reichl wrote: >>>> Odroid-X and -X2 have SPI_1 routed to an external connector. >>>> Enable SPI_1 on X and -X2. >>>> >>>> Signed-off-by: Markus Reichl <m.reichl@xxxxxxxxxxxxx> >>> Thanks for this patch. Maybe it would make sense also to enable I2C controller, >>> which is also available on the external connector? >> On -X and -X2 I2C-1 is routed to the connector. This bus has been already enabled, >> because the onboard MAX98090 codec is connected to it, too. > > Right, I was convinced that there is a second i2c bus routed there on X/X2, but it > turned out to be the same bus a the one used for audio codec. You are right, there is a second i2c bus (I2C-5) on the header pins 7/8. I will send a patch to enable I2C-5 when I have had the chance to successfully test it with a sensor. -- Markus > >> On U3 there is no native I2C-Bus on the connector. One would have to emulate it >> with the provided GPIOs using i2c-gpio. I think that should not go into the generic >> DTS. > > Right. No point adding software emulated buses. > > Best regards -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |