Hi Markus,
On 2016-11-25 15:02, Markus Reichl wrote:
Am 25.11.2016 um 14:39 schrieb Marek Szyprowski:
On 2016-11-24 15:13, Markus Reichl wrote:
Odroid-X and -X2 have SPI_1 routed to an external connector.
Enable SPI_1 on X and -X2.
Signed-off-by: Markus Reichl <m.reichl@xxxxxxxxxxxxx>
Thanks for this patch. Maybe it would make sense also to enable I2C controller,
which is also available on the external connector?
On -X and -X2 I2C-1 is routed to the connector. This bus has been already enabled,
because the onboard MAX98090 codec is connected to it, too.
Right, I was convinced that there is a second i2c bus routed there on
X/X2, but it
turned out to be the same bus a the one used for audio codec.
On U3 there is no native I2C-Bus on the connector. One would have to emulate it
with the provided GPIOs using i2c-gpio. I think that should not go into the generic
DTS.
Right. No point adding software emulated buses.
Best regards
--
Marek Szyprowski, PhD
Samsung R&D Institute Poland
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
