On 17 June 2013 17:26, Kukjin Kim <kgene.kim@xxxxxxxxxxx> wrote: > Chander Kashyap wrote: >> >> Exynos5420 is new SoC in Samsung's Exynos5 SoC series. This series adds >> initial support for this SoC. >> Changes since v2: >> >> 1. Renamed oscclk to fin_pll, in order to keep it consistant with >> Exynos4/Exynos5 >> 2. Pass memory as single bank rather than splitting in 256MB size banks. >> >> Changes since v1: >> >> 1. As not-dt platforms will not be supported from 3.11 onwards, following >> patches from previous patch series are dropped: >> "irqchip: exynos-combiner: set irq base as 256 for Exynos5420" >> "ARM: Exynos: initialize l2x0 cache controller only for cortex-a9 based >> SoCs" >> 2. Added device type property in cpu node in the following patch: >> "ARM: dts: list the CPU nodes for Exynos5250 >> 3. Sorted out the nodes listed in based upon the physical addresses as >> suggested >> by Tomasz Figa. >> 4. As Tomasz is going to consolidate the secondary cpu power register >> address >> calculation in all possible scnarios, hence dropped the following > patch: >> "ARM: Exynos: fix secondary cpu power control register address >> calculation" >> 5. Replaced the setup/remove)_irq calls with (request/free)_irq calls as >> suggested by Mark Rutland in patch: >> "clocksource: exynos_mct: use (request/free)_irq calls for local timer >> registration" >> 6. Changed the registration of epll and rpll from pll35xx to pl36xx. >> 7. Changed driver data selection for serial port, based on ARCH_EXYNOS. >> 8. Changed the interrupt cells from 2 to 1 as suggested by Tomasz Figa. >> >> Chander Kashyap (10): >> ARM: dts: fork out common Exynos5 nodes >> ARM: dts: list the CPU nodes for Exynos5250 >> ARM: Exynos: Add support for Exynos5420 SoC >> serial: samsung: select Exynos specific driver data if ARCH_EXYNOS is >> defined >> ARM: Exynos: use four additional chipid bits to identify Exynos >> family >> clk: exynos5420: register clocks using common clock framework >> ARM: dts: Add initial device tree support for Exynos5420 >> clocksource: exynos_mct: use (request/free)_irq calls for local timer >> registration >> ARM: Exynos: add secondary CPU boot base location for Exynos5420 >> ARM: Exynos: extend soft-reset support for Exynos5420 >> >> .../devicetree/bindings/clock/exynos5420-clock.txt | 201 ++++++ >> arch/arm/boot/dts/Makefile | 1 + >> arch/arm/boot/dts/exynos5.dtsi | 111 +++ >> arch/arm/boot/dts/exynos5250.dtsi | 80 +- >> arch/arm/boot/dts/exynos5420-smdk5420.dts | 33 + >> arch/arm/boot/dts/exynos5420.dtsi | 103 +++ >> arch/arm/mach-exynos/Kconfig | 10 + >> arch/arm/mach-exynos/common.c | 18 +- >> arch/arm/mach-exynos/include/mach/uncompress.h | 7 +- >> arch/arm/mach-exynos/mach-exynos5-dt.c | 1 + >> arch/arm/mach-exynos/platsmp.c | 12 +- >> arch/arm/plat-samsung/include/plat/cpu.h | 8 + >> drivers/clk/samsung/Makefile | 1 + >> drivers/clk/samsung/clk-exynos5420.c | 762 >> ++++++++++++++++++++ >> drivers/clocksource/exynos_mct.c | 35 +- >> drivers/tty/serial/samsung.c | 4 +- >> 16 files changed, 1280 insertions(+), 107 deletions(-) >> create mode 100644 Documentation/devicetree/bindings/clock/exynos5420- >> clock.txt >> create mode 100644 arch/arm/boot/dts/exynos5.dtsi >> create mode 100644 arch/arm/boot/dts/exynos5420-smdk5420.dts >> create mode 100644 arch/arm/boot/dts/exynos5420.dtsi >> create mode 100644 drivers/clk/samsung/clk-exynos5420.c >> >> -- >> 1.7.9.5 > > Chander, basically looks good to me but there are some comments on several > patches. Thanks Kukjin. > > Please address comments then, let me take this series after getting Mike's > ack on clock stuff. I will address the comments and resend. > > Thanks, > - Kukjin > -- with warm regards, Chander Kashyap -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |