Chander Kashyap wrote: > > Exynos5420 is new SoC in Samsung's Exynos5 SoC series. This series adds > initial support for this SoC. > Changes since v2: > > 1. Renamed oscclk to fin_pll, in order to keep it consistant with > Exynos4/Exynos5 > 2. Pass memory as single bank rather than splitting in 256MB size banks. > > Changes since v1: > > 1. As not-dt platforms will not be supported from 3.11 onwards, following > patches from previous patch series are dropped: > "irqchip: exynos-combiner: set irq base as 256 for Exynos5420" > "ARM: Exynos: initialize l2x0 cache controller only for cortex-a9 based > SoCs" > 2. Added device type property in cpu node in the following patch: > "ARM: dts: list the CPU nodes for Exynos5250 > 3. Sorted out the nodes listed in based upon the physical addresses as > suggested > by Tomasz Figa. > 4. As Tomasz is going to consolidate the secondary cpu power register > address > calculation in all possible scnarios, hence dropped the following patch: > "ARM: Exynos: fix secondary cpu power control register address > calculation" > 5. Replaced the setup/remove)_irq calls with (request/free)_irq calls as > suggested by Mark Rutland in patch: > "clocksource: exynos_mct: use (request/free)_irq calls for local timer > registration" > 6. Changed the registration of epll and rpll from pll35xx to pl36xx. > 7. Changed driver data selection for serial port, based on ARCH_EXYNOS. > 8. Changed the interrupt cells from 2 to 1 as suggested by Tomasz Figa. > > Chander Kashyap (10): > ARM: dts: fork out common Exynos5 nodes > ARM: dts: list the CPU nodes for Exynos5250 > ARM: Exynos: Add support for Exynos5420 SoC > serial: samsung: select Exynos specific driver data if ARCH_EXYNOS is > defined > ARM: Exynos: use four additional chipid bits to identify Exynos > family > clk: exynos5420: register clocks using common clock framework > ARM: dts: Add initial device tree support for Exynos5420 > clocksource: exynos_mct: use (request/free)_irq calls for local timer > registration > ARM: Exynos: add secondary CPU boot base location for Exynos5420 > ARM: Exynos: extend soft-reset support for Exynos5420 > > .../devicetree/bindings/clock/exynos5420-clock.txt | 201 ++++++ > arch/arm/boot/dts/Makefile | 1 + > arch/arm/boot/dts/exynos5.dtsi | 111 +++ > arch/arm/boot/dts/exynos5250.dtsi | 80 +- > arch/arm/boot/dts/exynos5420-smdk5420.dts | 33 + > arch/arm/boot/dts/exynos5420.dtsi | 103 +++ > arch/arm/mach-exynos/Kconfig | 10 + > arch/arm/mach-exynos/common.c | 18 +- > arch/arm/mach-exynos/include/mach/uncompress.h | 7 +- > arch/arm/mach-exynos/mach-exynos5-dt.c | 1 + > arch/arm/mach-exynos/platsmp.c | 12 +- > arch/arm/plat-samsung/include/plat/cpu.h | 8 + > drivers/clk/samsung/Makefile | 1 + > drivers/clk/samsung/clk-exynos5420.c | 762 > ++++++++++++++++++++ > drivers/clocksource/exynos_mct.c | 35 +- > drivers/tty/serial/samsung.c | 4 +- > 16 files changed, 1280 insertions(+), 107 deletions(-) > create mode 100644 Documentation/devicetree/bindings/clock/exynos5420- > clock.txt > create mode 100644 arch/arm/boot/dts/exynos5.dtsi > create mode 100644 arch/arm/boot/dts/exynos5420-smdk5420.dts > create mode 100644 arch/arm/boot/dts/exynos5420.dtsi > create mode 100644 drivers/clk/samsung/clk-exynos5420.c > > -- > 1.7.9.5 Chander, basically looks good to me but there are some comments on several patches. Please address comments then, let me take this series after getting Mike's ack on clock stuff. Thanks, - Kukjin -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |