Enable PCIe Host controller channel 0 on R-Car S4-8 Spider board.
Since this board has an Oculink connector, CLKREQ# pin of PFC for PCIe
should not be used. So, using a GPIO is used to output the clock instead.
Otherwise the controller cannot detect a PCIe device.
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>
---
.../boot/dts/renesas/r8a779f0-spider-cpu.dtsi | 19 +++++++++++++++++++
1 file changed, 19 insertions(+)
diff --git a/arch/arm64/boot/dts/renesas/r8a779f0-spider-cpu.dtsi b/arch/arm64/boot/dts/renesas/r8a779f0-spider-cpu.dtsi
index dd8e0e159526..12f2a1db4fb7 100644
--- a/arch/arm64/boot/dts/renesas/r8a779f0-spider-cpu.dtsi
+++ b/arch/arm64/boot/dts/renesas/r8a779f0-spider-cpu.dtsi
@@ -66,6 +66,14 @@ &extalr_clk {
clock-frequency = <32768>;
};
+&gpio2 {
+ pci-clkreq0-hog {
+ gpio-hog;
+ gpios = <15 GPIO_ACTIVE_LOW>;
+ output-high;
+ };
+};
+
&hscif0 {
pinctrl-0 = <&hscif0_pins>;
pinctrl-names = "default";
@@ -86,6 +94,12 @@ gpio_exp_20: gpio@20 {
reg = <0x20>;
gpio-controller;
#gpio-cells = <2>;
+
+ rc21012-gpio2-hog {
+ gpio-hog;
+ gpios = <5 GPIO_ACTIVE_LOW>;
+ output-high;
+ };
};
};
@@ -125,6 +139,11 @@ &mmc0 {
status = "okay";
};
+&pciec0 {
+ reset-gpio = <&gpio_exp_20 0 GPIO_ACTIVE_LOW>;
+ status = "okay";
+};
+
&pfc {
pinctrl-0 = <&scif_clk_pins>;
pinctrl-names = "default";
--
2.25.1
