Hi Laurent,
Thanks for your feedback.
On 2018-10-05 01:36:11 +0300, Laurent Pinchart wrote:
> Hi Niklas,
>
> Thank you for the patch.
>
> On Thursday, 4 October 2018 23:41:35 EEST Niklas Söderlund wrote:
> > From: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
> >
> > Reorder the initialization order of registers to allow for refactoring.
> > The move could have been done at the same time as the refactoring but
> > since the documentation about some registers involved are missing do it
> > separately.
> >
> > Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
> > ---
> > drivers/media/i2c/adv748x/adv748x-core.c | 12 +++++++-----
> > 1 file changed, 7 insertions(+), 5 deletions(-)
> >
> > diff --git a/drivers/media/i2c/adv748x/adv748x-core.c
> > b/drivers/media/i2c/adv748x/adv748x-core.c index
> > 6854d898fdd1f192..721ed6552bc1cde6 100644
> > --- a/drivers/media/i2c/adv748x/adv748x-core.c
> > +++ b/drivers/media/i2c/adv748x/adv748x-core.c
> > @@ -383,8 +383,6 @@ static const struct adv748x_reg_value
> > adv748x_init_txa_4lane[] = { {ADV748X_PAGE_IO, 0x0c, 0xe0}, /* Enable
> > LLC_DLL & Double LLC Timing */ {ADV748X_PAGE_IO, 0x0e, 0xdd}, /*
> > LLC/PIX/SPI PINS TRISTATED AUD */
> >
> > - {ADV748X_PAGE_TXA, 0x00, 0x84}, /* Enable 4-lane MIPI */
> > - {ADV748X_PAGE_TXA, 0x00, 0xa4}, /* Set Auto DPHY Timing */
> > {ADV748X_PAGE_TXA, 0xdb, 0x10}, /* ADI Required Write */
> > {ADV748X_PAGE_TXA, 0xd6, 0x07}, /* ADI Required Write */
> > {ADV748X_PAGE_TXA, 0xc4, 0x0a}, /* ADI Required Write */
> > @@ -392,6 +390,9 @@ static const struct adv748x_reg_value
> > adv748x_init_txa_4lane[] = { {ADV748X_PAGE_TXA, 0x72, 0x11}, /* ADI
> > Required Write */
> > {ADV748X_PAGE_TXA, 0xf0, 0x00}, /* i2c_dphy_pwdn - 1'b0 */
> >
> > + {ADV748X_PAGE_TXA, 0x00, 0x84}, /* Enable 4-lane MIPI */
> > + {ADV748X_PAGE_TXA, 0x00, 0xa4}, /* Set Auto DPHY Timing */
> > +
> > {ADV748X_PAGE_TXA, 0x31, 0x82}, /* ADI Required Write */
> > {ADV748X_PAGE_TXA, 0x1e, 0x40}, /* ADI Required Write */
> > {ADV748X_PAGE_TXA, 0xda, 0x01}, /* i2c_mipi_pll_en - 1'b1 */
> > @@ -435,17 +436,18 @@ static const struct adv748x_reg_value
> > adv748x_init_txb_1lane[] = { {ADV748X_PAGE_SDP, 0x31, 0x12}, /* ADI
> > Required Write */
> > {ADV748X_PAGE_SDP, 0xe6, 0x4f}, /* V bit end pos manually in NTSC */
> >
> > - {ADV748X_PAGE_TXB, 0x00, 0x81}, /* Enable 1-lane MIPI */
> > - {ADV748X_PAGE_TXB, 0x00, 0xa1}, /* Set Auto DPHY Timing */
> > {ADV748X_PAGE_TXB, 0xd2, 0x40}, /* ADI Required Write */
> > {ADV748X_PAGE_TXB, 0xc4, 0x0a}, /* ADI Required Write */
> > {ADV748X_PAGE_TXB, 0x71, 0x33}, /* ADI Required Write */
> > {ADV748X_PAGE_TXB, 0x72, 0x11}, /* ADI Required Write */
> > {ADV748X_PAGE_TXB, 0xf0, 0x00}, /* i2c_dphy_pwdn - 1'b0 */
> > +
> > + {ADV748X_PAGE_TXB, 0x00, 0x81}, /* Enable 1-lane MIPI */
> > + {ADV748X_PAGE_TXB, 0x00, 0xa1}, /* Set Auto DPHY Timing */
> > +
>
> This is pretty hard to review, as there's a bunch of undocumented register
> writes. I think the first write is safe, as the tables are written immediately
> following a software reset, and the default value of the register is 0x81
> (CSI-TX disabled, 1 lane). The second write, however, enables usage of the
> computed DPHY parameters, and I don't know whether the undocumented register
> writes in-between may interact with that.
I agree it's hard to grasp all implications with undocumented registers
involved. That is why I choose to do it in a separate commit so if
regressions are found it could be bisectable to this change.
>
> That being said, this change enables further important refactoring, so I'm
> tempted to accept it. I assume you've tested it and haven't noticed a
> regression. The part that still bothers me in particular is that the write to
> register 0xf0 just above this takes the DPHY out of power down according to
> the datasheet, and I wonder whether at that point the DPHY might not react to
> that information. Have you analyzed the power-up sequence in section 9.5.1 of
> the hardware manual ? I wonder whether the dphy_pwdn shouldn't be handled in
> the power up and power down sequences, which might involve also moving the
> above four (and five for TXA) undocumented writes to the power up sequence as
> well.
I looked at the documentation and ran lots of tests based on this change
and noticed no change in behavior.
>
> > {ADV748X_PAGE_TXB, 0x31, 0x82}, /* ADI Required Write */
> > {ADV748X_PAGE_TXB, 0x1e, 0x40}, /* ADI Required Write */
> > {ADV748X_PAGE_TXB, 0xda, 0x01}, /* i2c_mipi_pll_en - 1'b1 */
> > -
> > {ADV748X_PAGE_WAIT, 0x00, 0x02},/* delay 2 */
> > {ADV748X_PAGE_TXB, 0x00, 0x21 },/* Power-up CSI-TX */
> > {ADV748X_PAGE_WAIT, 0x00, 0x01},/* delay 1 */
>
> --
> Regards,
>
> Laurent Pinchart
>
>
>
--
Regards,
Niklas Söderlund
