Hi Niklas,
Thank you for the patch.
On Thursday, 4 October 2018 23:41:35 EEST Niklas Söderlund wrote:
> From: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
>
> Reorder the initialization order of registers to allow for refactoring.
> The move could have been done at the same time as the refactoring but
> since the documentation about some registers involved are missing do it
> separately.
>
> Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
> ---
> drivers/media/i2c/adv748x/adv748x-core.c | 12 +++++++-----
> 1 file changed, 7 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/media/i2c/adv748x/adv748x-core.c
> b/drivers/media/i2c/adv748x/adv748x-core.c index
> 6854d898fdd1f192..721ed6552bc1cde6 100644
> --- a/drivers/media/i2c/adv748x/adv748x-core.c
> +++ b/drivers/media/i2c/adv748x/adv748x-core.c
> @@ -383,8 +383,6 @@ static const struct adv748x_reg_value
> adv748x_init_txa_4lane[] = { {ADV748X_PAGE_IO, 0x0c, 0xe0}, /* Enable
> LLC_DLL & Double LLC Timing */ {ADV748X_PAGE_IO, 0x0e, 0xdd}, /*
> LLC/PIX/SPI PINS TRISTATED AUD */
>
> - {ADV748X_PAGE_TXA, 0x00, 0x84}, /* Enable 4-lane MIPI */
> - {ADV748X_PAGE_TXA, 0x00, 0xa4}, /* Set Auto DPHY Timing */
> {ADV748X_PAGE_TXA, 0xdb, 0x10}, /* ADI Required Write */
> {ADV748X_PAGE_TXA, 0xd6, 0x07}, /* ADI Required Write */
> {ADV748X_PAGE_TXA, 0xc4, 0x0a}, /* ADI Required Write */
> @@ -392,6 +390,9 @@ static const struct adv748x_reg_value
> adv748x_init_txa_4lane[] = { {ADV748X_PAGE_TXA, 0x72, 0x11}, /* ADI
> Required Write */
> {ADV748X_PAGE_TXA, 0xf0, 0x00}, /* i2c_dphy_pwdn - 1'b0 */
>
> + {ADV748X_PAGE_TXA, 0x00, 0x84}, /* Enable 4-lane MIPI */
> + {ADV748X_PAGE_TXA, 0x00, 0xa4}, /* Set Auto DPHY Timing */
> +
> {ADV748X_PAGE_TXA, 0x31, 0x82}, /* ADI Required Write */
> {ADV748X_PAGE_TXA, 0x1e, 0x40}, /* ADI Required Write */
> {ADV748X_PAGE_TXA, 0xda, 0x01}, /* i2c_mipi_pll_en - 1'b1 */
> @@ -435,17 +436,18 @@ static const struct adv748x_reg_value
> adv748x_init_txb_1lane[] = { {ADV748X_PAGE_SDP, 0x31, 0x12}, /* ADI
> Required Write */
> {ADV748X_PAGE_SDP, 0xe6, 0x4f}, /* V bit end pos manually in NTSC */
>
> - {ADV748X_PAGE_TXB, 0x00, 0x81}, /* Enable 1-lane MIPI */
> - {ADV748X_PAGE_TXB, 0x00, 0xa1}, /* Set Auto DPHY Timing */
> {ADV748X_PAGE_TXB, 0xd2, 0x40}, /* ADI Required Write */
> {ADV748X_PAGE_TXB, 0xc4, 0x0a}, /* ADI Required Write */
> {ADV748X_PAGE_TXB, 0x71, 0x33}, /* ADI Required Write */
> {ADV748X_PAGE_TXB, 0x72, 0x11}, /* ADI Required Write */
> {ADV748X_PAGE_TXB, 0xf0, 0x00}, /* i2c_dphy_pwdn - 1'b0 */
> +
> + {ADV748X_PAGE_TXB, 0x00, 0x81}, /* Enable 1-lane MIPI */
> + {ADV748X_PAGE_TXB, 0x00, 0xa1}, /* Set Auto DPHY Timing */
> +
This is pretty hard to review, as there's a bunch of undocumented register
writes. I think the first write is safe, as the tables are written immediately
following a software reset, and the default value of the register is 0x81
(CSI-TX disabled, 1 lane). The second write, however, enables usage of the
computed DPHY parameters, and I don't know whether the undocumented register
writes in-between may interact with that.
That being said, this change enables further important refactoring, so I'm
tempted to accept it. I assume you've tested it and haven't noticed a
regression. The part that still bothers me in particular is that the write to
register 0xf0 just above this takes the DPHY out of power down according to
the datasheet, and I wonder whether at that point the DPHY might not react to
that information. Have you analyzed the power-up sequence in section 9.5.1 of
the hardware manual ? I wonder whether the dphy_pwdn shouldn't be handled in
the power up and power down sequences, which might involve also moving the
above four (and five for TXA) undocumented writes to the power up sequence as
well.
> {ADV748X_PAGE_TXB, 0x31, 0x82}, /* ADI Required Write */
> {ADV748X_PAGE_TXB, 0x1e, 0x40}, /* ADI Required Write */
> {ADV748X_PAGE_TXB, 0xda, 0x01}, /* i2c_mipi_pll_en - 1'b1 */
> -
> {ADV748X_PAGE_WAIT, 0x00, 0x02},/* delay 2 */
> {ADV748X_PAGE_TXB, 0x00, 0x21 },/* Power-up CSI-TX */
> {ADV748X_PAGE_WAIT, 0x00, 0x01},/* delay 1 */
--
Regards,
Laurent Pinchart
