If anything fails past phy_init_fn() and the system is a Gen3 with
a PHY, the PHY will be left on and inited. This is caused by the
phy_init_fn, which is in fact a pointer to rcar_pcie_phy_init_gen3()
function, which starts the PHY, yet has no counterpart in the failpath.
Add that counterpart.
Signed-off-by: Marek Vasut <marek.vasut+renesas@xxxxxxxxx>
Cc: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
Cc: Lorenzo Pieralisi <lorenzo.pieralisi@xxxxxxx>
Cc: Phil Edworthy <phil.edworthy@xxxxxxxxxxx>
Cc: Simon Horman <horms+renesas@xxxxxxxxxxxx>
Cc: Wolfram Sang <wsa@xxxxxxxxxxxxx>
Cc: linux-renesas-soc@xxxxxxxxxxxxxxx
Fixes: 517ca93a7159 ("PCI: rcar: Add R-Car gen3 PHY support")
---
V4: New patch
---
drivers/pci/host/pcie-rcar.c | 10 ++++++++--
1 file changed, 8 insertions(+), 2 deletions(-)
diff --git a/drivers/pci/host/pcie-rcar.c b/drivers/pci/host/pcie-rcar.c
index 636c3c5095d2..695781934f0a 100644
--- a/drivers/pci/host/pcie-rcar.c
+++ b/drivers/pci/host/pcie-rcar.c
@@ -1163,7 +1163,7 @@ static int rcar_pcie_probe(struct platform_device *pdev)
if (rcar_pcie_hw_init(pcie)) {
dev_info(dev, "PCIe link down\n");
err = -ENODEV;
- goto err_clk_disable;
+ goto err_phy_shutdown;
}
data = rcar_pci_read_reg(pcie, MACSR);
@@ -1175,7 +1175,7 @@ static int rcar_pcie_probe(struct platform_device *pdev)
dev_err(dev,
"failed to enable MSI support: %d\n",
err);
- goto err_clk_disable;
+ goto err_phy_shutdown;
}
}
@@ -1189,6 +1189,12 @@ static int rcar_pcie_probe(struct platform_device *pdev)
if (IS_ENABLED(CONFIG_PCI_MSI))
rcar_pcie_teardown_msi(pcie);
+err_phy_shutdown:
+ if (pcie->phy) {
+ phy_power_off(pcie->phy);
+ phy_exit(pcie->phy);
+ }
+
err_clk_disable:
clk_disable_unprepare(pcie->bus_clk);
--
2.16.2
