Re: [PATCH 0/3] arm64: dts: renesas: r8a77970: connect VIN to CSI40

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Simon,

On 2017-11-29 10:53:17 +0100, Simon Horman wrote:
> On Sun, Nov 26, 2017 at 01:50:09AM +0100, Niklas Söderlund wrote:
> > Hi,
> > 
> > This series describes how to connect VIN0-3 to CSI40 and the HDMI input 
> > of the adv7482 on the expansion board. It is tested on V3M together with 
> > V3M enablement for VIN and CSI-2 drivers on-top of Kieran's 
> > renesas-drivers-next-v3m branch [1].
> > 
> > It works and it's possible to program the EDID and capture frame frames.  
> > Remember to switch SW18 to the off position to route the CSI-2 bus to 
> > the expansion board instead of the MAX9286 for GMSL input.
> > 
> > 1. git://git.kernel.org/pub/scm/linux/kernel/git/kbingham/rcar.git
> 
> Hi Niklas,
> 
> how do you view the path to upstream of this patch-set?

I think there are a few things that needs to go upstream before this 
set.

- The VIN and CSI-2 Gen3 driver support.
- All or some of the V3M DT patches from renesas-drivers-next-v3m.

I would mark this as deferred as I expect some of the patches in 
renesas-drivers-next-v3m needs more work and therefor this set also 
needs to be updated before it's ready to go upstream.

-- 
Regards,
Niklas Söderlund



[Index of Archives]     [Linux Samsung SOC]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux