On Wed, Nov 29, 2017 at 01:32:08PM +0100, Niklas Söderlund wrote: > Hi Simon, > > On 2017-11-29 10:53:17 +0100, Simon Horman wrote: > > On Sun, Nov 26, 2017 at 01:50:09AM +0100, Niklas Söderlund wrote: > > > Hi, > > > > > > This series describes how to connect VIN0-3 to CSI40 and the HDMI input > > > of the adv7482 on the expansion board. It is tested on V3M together with > > > V3M enablement for VIN and CSI-2 drivers on-top of Kieran's > > > renesas-drivers-next-v3m branch [1]. > > > > > > It works and it's possible to program the EDID and capture frame frames. > > > Remember to switch SW18 to the off position to route the CSI-2 bus to > > > the expansion board instead of the MAX9286 for GMSL input. > > > > > > 1. git://git.kernel.org/pub/scm/linux/kernel/git/kbingham/rcar.git > > > > Hi Niklas, > > > > how do you view the path to upstream of this patch-set? > > I think there are a few things that needs to go upstream before this > set. > > - The VIN and CSI-2 Gen3 driver support. > - All or some of the V3M DT patches from renesas-drivers-next-v3m. > > I would mark this as deferred as I expect some of the patches in > renesas-drivers-next-v3m needs more work and therefor this set also > needs to be updated before it's ready to go upstream. Understood, I have marked them as deferred as you suggest.