On Fri, Nov 23, 2018 at 8:18 AM Miquel Raynal <miquel.raynal@xxxxxxxxxxx> wrote: > > Hello, > > As part of an effort to bring suspend to RAM support to Armada 3700 > SoCs (main target: ESPRESSObin), this series handles the work around > the PCIe IP. > > First, more configuration is done in the 'setup' helper as inspired > from the U-Boot driver. This is needed to entirely initialize the IP > during future resume operation (patch 1). > > Then, reset GPIO, PHY and clock support are introduced (patch 2-4). As > current device trees do not provide the corresponding properties, not > finding one of these properties is not an error and just produces a > warning. However, if the property is present, an error during PHY > initialization will fail the probe of the driver. > > Note: To be sure the clock will be resumed before this driver, a first > series adding links between clocks and consumers has been submitted, > see [1]. > > Patch 5 adds suspend/resume hooks, re-using all the above. > > Finally, bindings and device trees are updated to reflect the hardware > (patch 6-12). While the clock depends on the SoC, the reset GPIO and > the PHY depends on the board so the clock is added in the > armada-37xx.dtsi file while the two other properties are added in > armada-3720-espressobin.dts. > > [1] http://lists.infradead.org/pipermail/linux-arm-kernel/2018-November/614527.html > > Thanks, > Miquèl > > > Miquel Raynal (12): > PCI: aardvark: configure more registers in the configuration helper > PCI: aardvark: add reset GPIO support > PCI: aardvark: add PHY support > PCI: aardvark: add clock support > PCI: aardvark: add suspend to RAM support > dt-bindings: PCI: aardvark: describe the reset-gpios property > dt-bindings: PCI: aardvark: describe the clocks property > dt-bindings: PCI: aardvark: describe the PHY property > ARM64: dts: marvell: armada-37xx: declare PCIe reset pin > ARM64: dts: marvell: armada-3720-espressobin: declare PCIe reset GPIO > ARM64: dts: marvell: armada-37xx: declare PCIe clock > ARM64: dts: marvell: armada-3720-espressobin: declare PCIe PHY Hi Miquèl, Thanks for your work! If/when you post a v2, please run "git log --oneline" and adjust your subject lines to match the capitalization conventions, i.e., for PCI, start the description with a capital letter: "PCI: aardvark: Add suspend to RAM support". BTW, I notice you closed your email with "Miquèl", but the patches contain "Miquel". you *should* be able to use the correctly accented version of your name in the Signed-off-by lines. I have tripped over some tool issues, but if we pay attention, we should be able to get it to work. > .../devicetree/bindings/pci/aardvark-pci.txt | 9 + > .../dts/marvell/armada-3720-espressobin.dts | 4 + > arch/arm64/boot/dts/marvell/armada-37xx.dtsi | 5 + > drivers/pci/controller/pci-aardvark.c | 214 ++++++++++++++++++ > 4 files changed, 232 insertions(+) > > -- > 2.19.1 >
