[PATCH 00/12] Bring suspend to RAM support to PCIe Aardvark driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hello,

As part of an effort to bring suspend to RAM support to Armada 3700
SoCs (main target: ESPRESSObin), this series handles the work around
the PCIe IP.

First, more configuration is done in the 'setup' helper as inspired
from the U-Boot driver. This is needed to entirely initialize the IP
during future resume operation (patch 1).

Then, reset GPIO, PHY and clock support are introduced (patch 2-4). As
current device trees do not provide the corresponding properties, not
finding one of these properties is not an error and just produces a
warning. However, if the property is present, an error during PHY
initialization will fail the probe of the driver.

Note: To be sure the clock will be resumed before this driver, a first
series adding links between clocks and consumers has been submitted,
see [1].

Patch 5 adds suspend/resume hooks, re-using all the above.

Finally, bindings and device trees are updated to reflect the hardware
(patch 6-12). While the clock depends on the SoC, the reset GPIO and
the PHY depends on the board so the clock is added in the
armada-37xx.dtsi file while the two other properties are added in
armada-3720-espressobin.dts.

[1] http://lists.infradead.org/pipermail/linux-arm-kernel/2018-November/614527.html

Thanks,
Miquèl


Miquel Raynal (12):
  PCI: aardvark: configure more registers in the configuration helper
  PCI: aardvark: add reset GPIO support
  PCI: aardvark: add PHY support
  PCI: aardvark: add clock support
  PCI: aardvark: add suspend to RAM support
  dt-bindings: PCI: aardvark: describe the reset-gpios property
  dt-bindings: PCI: aardvark: describe the clocks property
  dt-bindings: PCI: aardvark: describe the PHY property
  ARM64: dts: marvell: armada-37xx: declare PCIe reset pin
  ARM64: dts: marvell: armada-3720-espressobin: declare PCIe reset GPIO
  ARM64: dts: marvell: armada-37xx: declare PCIe clock
  ARM64: dts: marvell: armada-3720-espressobin: declare PCIe PHY

 .../devicetree/bindings/pci/aardvark-pci.txt  |   9 +
 .../dts/marvell/armada-3720-espressobin.dts   |   4 +
 arch/arm64/boot/dts/marvell/armada-37xx.dtsi  |   5 +
 drivers/pci/controller/pci-aardvark.c         | 214 ++++++++++++++++++
 4 files changed, 232 insertions(+)

-- 
2.19.1




[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux