Add QPS615 PCIe switch node which has 3 downstream ports and in one
downstream port two embedded ethernet devices are present.
Power to the QPS615 is supplied through two LDO regulators, controlled
by two GPIOs, these are added as fixed regulators. And the QPS615 is
configured through i2c.
Signed-off-by: Krishna chaitanya chundru <quic_krichai@xxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts | 115 +++++++++++++++++++++++++++
arch/arm64/boot/dts/qcom/sc7280.dtsi | 2 +-
2 files changed, 116 insertions(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
index 0d45662b8028..0e890841b600 100644
--- a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
+++ b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
@@ -202,6 +202,30 @@ vph_pwr: vph-pwr-regulator {
regulator-min-microvolt = <3700000>;
regulator-max-microvolt = <3700000>;
};
+
+ vdd_ntn_0p9: regulator-vdd-ntn-0p9 {
+ compatible = "regulator-fixed";
+ regulator-name = "VDD_NTN_0P9";
+ gpio = <&pm8350c_gpios 2 GPIO_ACTIVE_HIGH>;
+ regulator-min-microvolt = <899400>;
+ regulator-max-microvolt = <899400>;
+ enable-active-high;
+ pinctrl-0 = <&ntn_0p9_en>;
+ pinctrl-names = "default";
+ regulator-enable-ramp-delay = <4300>;
+ };
+
+ vdd_ntn_1p8: regulator-vdd-ntn-1p8 {
+ compatible = "regulator-fixed";
+ regulator-name = "VDD_NTN_1P8";
+ gpio = <&pm8350c_gpios 3 GPIO_ACTIVE_HIGH>;
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ enable-active-high;
+ pinctrl-0 = <&ntn_1p8_en>;
+ pinctrl-names = "default";
+ regulator-enable-ramp-delay = <10000>;
+ };
};
&apps_rsc {
@@ -684,6 +708,75 @@ &mdss_edp_phy {
status = "okay";
};
+&pcie1_port {
+ pcie@0,0 {
+ compatible = "pci1179,0623";
+ reg = <0x10000 0x0 0x0 0x0 0x0>;
+ #address-cells = <3>;
+ #size-cells = <2>;
+
+ device_type = "pci";
+ ranges;
+ bus-range = <0x2 0xff>;
+
+ vddc-supply = <&vdd_ntn_0p9>;
+ vdd18-supply = <&vdd_ntn_1p8>;
+ vdd09-supply = <&vdd_ntn_0p9>;
+ vddio1-supply = <&vdd_ntn_1p8>;
+ vddio2-supply = <&vdd_ntn_1p8>;
+ vddio18-supply = <&vdd_ntn_1p8>;
+
+ i2c-parent = <&i2c0 0x77>;
+
+ reset-gpios = <&pm8350c_gpios 1 GPIO_ACTIVE_LOW>;
+
+ pcie@1,0 {
+ reg = <0x20800 0x0 0x0 0x0 0x0>;
+ #address-cells = <3>;
+ #size-cells = <2>;
+
+ device_type = "pci";
+ ranges;
+ bus-range = <0x3 0xff>;
+ };
+
+ pcie@2,0 {
+ reg = <0x21000 0x0 0x0 0x0 0x0>;
+ #address-cells = <3>;
+ #size-cells = <2>;
+
+ device_type = "pci";
+ ranges;
+ bus-range = <0x4 0xff>;
+ };
+
+ pcie@3,0 {
+ reg = <0x21800 0x0 0x0 0x0 0x0>;
+ #address-cells = <3>;
+ #size-cells = <2>;
+ device_type = "pci";
+ ranges;
+ bus-range = <0x5 0xff>;
+
+ pcie@0,0 {
+ reg = <0x50000 0x0 0x0 0x0 0x0>;
+ #address-cells = <3>;
+ #size-cells = <2>;
+ device_type = "pci";
+ ranges;
+ };
+
+ pcie@0,1 {
+ reg = <0x50100 0x0 0x0 0x0 0x0>;
+ #address-cells = <3>;
+ #size-cells = <2>;
+ device_type = "pci";
+ ranges;
+ };
+ };
+ };
+};
+
&pmk8350_rtc {
status = "okay";
};
@@ -812,6 +905,28 @@ lt9611_rst_pin: lt9611-rst-state {
};
};
+&pm8350c_gpios {
+ ntn_0p9_en: ntn-0p9-en-state {
+ pins = "gpio2";
+ function = "normal";
+
+ bias-disable;
+ input-disable;
+ output-enable;
+ power-source = <0>;
+ };
+
+ ntn_1p8_en: ntn-1p8-en-state {
+ pins = "gpio3";
+ function = "normal";
+
+ bias-disable;
+ input-disable;
+ output-enable;
+ power-source = <0>;
+ };
+};
+
&tlmm {
lt9611_irq_pin: lt9611-irq-state {
pins = "gpio24";
diff --git a/arch/arm64/boot/dts/qcom/sc7280.dtsi b/arch/arm64/boot/dts/qcom/sc7280.dtsi
index 3d8410683402..82434f085ff0 100644
--- a/arch/arm64/boot/dts/qcom/sc7280.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7280.dtsi
@@ -2279,7 +2279,7 @@ pcie1: pcie@1c08000 {
status = "disabled";
- pcie@0 {
+ pcie1_port: pcie@0 {
device_type = "pci";
reg = <0x0 0x0 0x0 0x0 0x0>;
bus-range = <0x01 0xff>;
--
2.34.1
