On 7/7/2023 11:21 AM, Manivannan Sadhasivam wrote:
On Fri, Jun 30, 2023 at 04:22:05PM +0530, Krishna chaitanya chundru wrote:
Add support to pass D-state change notification to Endpoint
function driver.
Signed-off-by: Krishna chaitanya chundru <quic_krichai@xxxxxxxxxxx>
Few comments below.
---
drivers/pci/controller/dwc/pcie-qcom-ep.c | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/drivers/pci/controller/dwc/pcie-qcom-ep.c b/drivers/pci/controller/dwc/pcie-qcom-ep.c
index 1435f51..e75aec4 100644
--- a/drivers/pci/controller/dwc/pcie-qcom-ep.c
+++ b/drivers/pci/controller/dwc/pcie-qcom-ep.c
@@ -561,6 +561,7 @@ static irqreturn_t qcom_pcie_ep_global_irq_thread(int irq, void *data)
struct device *dev = pci->dev;
u32 status = readl_relaxed(pcie_ep->parf + PARF_INT_ALL_STATUS);
u32 mask = readl_relaxed(pcie_ep->parf + PARF_INT_ALL_MASK);
+ pci_power_t state;
u32 dstate, val;
writel_relaxed(status, pcie_ep->parf + PARF_INT_ALL_CLEAR);
@@ -583,11 +584,16 @@ static irqreturn_t qcom_pcie_ep_global_irq_thread(int irq, void *data)
dstate = dw_pcie_readl_dbi(pci, DBI_CON_STATUS) &
DBI_CON_STATUS_POWER_STATE_MASK;
dev_dbg(dev, "Received D%d state event\n", dstate);
We should also change this debug output to make use of pci_power_name() based on
the "state" variable and move it just above pci_epc_dstate_change(). But this
should be a separate patch.
I will add a seperate patch in the same series
+ state = dstate;
if (dstate == 3) {
val = readl_relaxed(pcie_ep->parf + PARF_PM_CTRL);
val |= PARF_PM_CTRL_REQ_EXIT_L1;
writel_relaxed(val, pcie_ep->parf + PARF_PM_CTRL);
+ state = PCI_D3hot;
+ if (gpiod_get_value(pcie_ep->reset))
+ state = PCI_D3cold;
}
+ pci_epc_dstate_change(pci->ep.epc, state);
Need to change this API as per my comment on patch 1.
- Mani
sure will change it as you suggested.
- KC
} else if (FIELD_GET(PARF_INT_ALL_LINK_UP, status)) {
dev_dbg(dev, "Received Linkup event. Enumeration complete!\n");
dw_pcie_ep_linkup(&pci->ep);
--
2.7.4
