[RFC PATCH 0/4] PCI: qcom: support using the same PHY for both RC and EP

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Programming of QMP PCIe PHYs slightly differs between RC and EP modes.

Currently both qcom and qcom-ep PCIe controllers setup the PHY in the
default mode, making it impossible to select at runtime whether the PHY
should be running in RC or in EP modes. Usually this is not an issue,
since for most devices only the RC mode is used, while for some (SDX55)
the EP mode is used without support for working as the RC.

Some of the Qualcomm platforms would still benefit from being able to
switch between RC and EP depending on the driver being used. While it is
possible to use different compat strings for the PHY depending on the
mode, it seems like an incorrect approach, since the PHY doesn't differ
between usecases. It's the PCIe controller, who should decide how to
configure the PHY.

This patch series implements the ability to select between RC and EP
modes, by allowing the PCIe QMP PHY driver to switch between
programming tables.

Dmitry Baryshkov (4):
  phy: qcom-qmp-pcie: split register tables into primary and secondary
    part
  phy: qcom-qmp-pcie: suppor separate tables for EP mode
  PCI: qcom: call phy_set_mode_ext()
  PCI: qcom-ep: call phy_set_mode_ext()

 drivers/pci/controller/dwc/pcie-qcom-ep.c |   4 +
 drivers/pci/controller/dwc/pcie-qcom.c    |   4 +
 drivers/phy/qualcomm/phy-qcom-qmp-pcie.c  | 155 ++++++++++++----------
 3 files changed, 96 insertions(+), 67 deletions(-)

-- 
2.35.1




[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux