On 10/13/2011 08:00 PM, Stefano Stabellini wrote:
On Mon, 10 Oct 2011, Ajaykumar Hotchandani wrote:
On 10/06/2011 09:47 PM, Stefano Stabellini wrote:
On Thu, 6 Oct 2011, Yinghai Lu wrote:
On Thu, Oct 6, 2011 at 3:39 AM, Stefano Stabellini
<stefano.stabellini@xxxxxxxxxxxxx> wrote:
I had the same issue and sent a patch a while ago to fix it, adding
current_state = PCI_D0 in acpiphp_glue.c:register_slot
it is strange that this does not work for you:
http://marc.info/?l=linux-kernel&m=129891002722845&w=2
So guest os has to load acpiphp instead of pciehp?
maybe pciehp needs to make sure that current_state = D0 in
pciehp_enable_slot, like acpiphp does
Here, acpi hotplugging is involved.
With your change in register_slot(), device will have proper power state when module is being loaded for the first time after booting.
However, while unload of pci module; following is in pci_device_remove():
if (pci_dev->current_state == PCI_D0)
pci_dev->current_state = PCI_UNKNOWN;
So, device power state state will remain PCI_UNKNOWN while module is loaded again. Subsequently, MSI write will do nothing.
Does this mean that this bug would actually trigger even with devices that
do support _EJ0 and power management?
Nope. I don't have system to verify. But, for the scenario you mentioned
(device is hot pluggable, acpi bus power manageable and device with
pm_cap supported; if I understand it correctly), following is what I
think should happen:
- Inside pci_platform_power_transition(),
platform_pci_power_manageable() will be successful. However,
platform_pci_set_power_state() will fail (as device supports EJ0) and
subsequently pci_update_current_state() will not get called.
- So, current power state of device will not be read and power state of
device will remain PCI_UNKNOWN.
- Now, pci_raw_set_power_state() will get called. Here, as current power
state is PCI_UNKNOWN, pci_write_config_word() will be called with pmcsr
value as 0. As, last two bits of pmcsr is 0, written power state of
device will be PCI_D0 now. And subsequently, dev->current_state will be
assigned as PCI_D0 (by using pci_read_config_word() ).
Because acpi_pci_set_power_state won't set current_state to PCI_D0
because the "hotplug driver will take care of _PSx" (see
10b3dcae0f275e2546e55303d64ddbb58cec7599) but the hotplug driver is not
actually invoked when loading again a driver module of an existing pci
device (the example you mention above)?
Can you please elaborate more on this?
acpi_bus_set_power() will update state of acpi_dev (ACPI_STATE_XX) and
not pci_dev (PCI_XX).
And here, issue lies with current_state of pci_dev.
Thanks,
Ajay
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
