At the moment, the switch statement in the artpec6_pcie_probe() has
a local code block where the local variable "val" is defined and
immediately used by the artpec6_pcie_readl() within this local scope.
This extra code block adds brackets at the same indentation level as the
switch statement itself which can hinder readability of the code.
Thus, move the variable "val" declaration and definition at the top of
the function where other variables are already present, and remove the
extra code block from within the select statement. This also is the
preferred style in the PCI tree.
Suggested-by: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>
Signed-off-by: Krzysztof Wilczyński <kw@xxxxxxxxx>
---
drivers/pci/controller/dwc/pcie-artpec6.c | 6 ++----
1 file changed, 2 insertions(+), 4 deletions(-)
diff --git a/drivers/pci/controller/dwc/pcie-artpec6.c b/drivers/pci/controller/dwc/pcie-artpec6.c
index 739871bece75..c91fc1954432 100644
--- a/drivers/pci/controller/dwc/pcie-artpec6.c
+++ b/drivers/pci/controller/dwc/pcie-artpec6.c
@@ -384,6 +384,7 @@ static int artpec6_pcie_probe(struct platform_device *pdev)
const struct artpec_pcie_of_data *data;
enum artpec_pcie_variants variant;
enum dw_pcie_device_mode mode;
+ u32 val;
match = of_match_device(artpec6_pcie_of_match, dev);
if (!match)
@@ -432,9 +433,7 @@ static int artpec6_pcie_probe(struct platform_device *pdev)
if (ret < 0)
return ret;
break;
- case DW_PCIE_EP_TYPE: {
- u32 val;
-
+ case DW_PCIE_EP_TYPE:
if (!IS_ENABLED(CONFIG_PCIE_ARTPEC6_EP))
return -ENODEV;
@@ -445,7 +444,6 @@ static int artpec6_pcie_probe(struct platform_device *pdev)
pci->ep.ops = &pcie_ep_ops;
return dw_pcie_ep_init(&pci->ep);
- }
default:
dev_err(dev, "INVALID device type %d\n", artpec6_pcie->mode);
}
--
2.32.0
