On Thursday 13 June 2013 04:17 PM, Lee Jones wrote:
On Thu, 13 Jun 2013, Linus Walleij wrote:
On Thu, Jun 6, 2013 at 9:14 PM, Balaji T K <balajitk@xxxxxx> wrote:
PBIAS register configuration is based on the regulator voltage
which supplies these pbias cells, sd i/o pads.
With PBIAS register address and bit definitions different across
omap[3,4,5], Simplify PBIAS configuration under three different
regulator voltage levels - O V, 1.8 V, 3 V. Corresponding pinctrl states
are defined as pbias_off, pbias_1v8, pbias_3v.
pinctrl state mmc_init is used for configuring speed mode, loopback clock
(in devconf0/devconf1/prog_io1 register for omap3) and pull strength
configuration (in control_mmc1 for omap4)
Signed-off-by: Balaji T K <balajitk@xxxxxx>
You *need* Lee Jones and Mark Brown to review this.
Maybe Laurent has something to add too.
Ux500 had the very same thing, and there this was solved using
a GPIO regulator for "vqmmc" a level-shifter. I vaguely remember
Laurent doing something similar with the SH stuff.
I haven't seem much of this patch-set, but this certainly looks like
it should be handled by a GPIO regulator instead of pinctrl. States
are easily declared in a 'struct gpio_regulator_state', which the
framework then uses to set the correct pins for the required voltage.
Thanks for the pointer, but wondering why is it named as gpio-regulator
and how it is different from fixed-regulator.
After going through git log description, I understand that voltage/current level
for a particular regulator is controlled by a set of pad/pin on the POWER IC
and pad/pin may be usually connected to gpio pins if it is needs to be
configurable and ground/pulled for constant voltage.
Collection of gpios logic level are modeled as state for particular voltage.
But gpio is not used in my case.
And yes, 'vqmmc' is a good place to store the this regulator.
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
